3d printer project ideas please

[phatfil]

Any suggestions for any useful vape related 3d printing projects? I have a very basic Anet A8 clone printer (cheapest on amazon - £89 - when i bought it)  which can print ok with PLA.

please be mindful that i am NOT skilled in any design techniques and have only used tinkercad to build basic models..   


Thanks in advance...
 

[qsplan]

Hello and congrats for your new toy...

I would make stands for atomizer, mods, e-liquids, etc...

[izan]

Very jealous!

Perhaps a battery dispenser?



Cheers
I

[thebishman]

Id love a 3d printer!! What about a box to make mech mod?

[phatfil]

Thanks folks.. Ive been browsing thingiverse for inspiration too

I should clarify tho its Not a new toy. More of a dust catcher atm.. . bought a while back when refitting smart light switches in the house.. the depth of the new switches exceeded the depth of the existing shallow boxes mounted in the brick walls.. I could have dug them out...(hard work). but adding stand offs upto 25mm seemed a lot easier unfortunately the off the shelf options i found were VERY expensive and only 5mm deep meaning it could cost upto £30 per plate to fit!! ouch - enter the cheap 3d printer to print off a range of 5mm-25mm stand offs

tbh the design aspect of the hobby was a bit too much of a bite for me to chew comfortably at the time. . But now with isolation at home and time on my hands im looking at diving back in..


Atty stands seem like a great start .. battery boxes.. i will need to collect more batteries before i need those, but Yeah another good idea

I think however a box mod might be a tad ambitious as the pla that i can print with isnt that good when it comes to heat resistance in use..
But then again nothing ventured....


Perhaps an atty stand incorporating a small wooden clothes peg or spring? to grip the bottom 510 thread to facilitate pulling off a top cap ?? hmm

back to watching kid vids on using tinkercad i guess..