Vision ego

[Dream (s)]

I received the vision ego kit on Saturday and I'm just not happy with it! I compare it to a Riva (hubby's) and that one is so much better while vaping.
The problem I'm having with the ego is? as I try to inhale with it with the vision cartomiser attached, all I seem to get is air and it makes an airy noise, the inhale doesn't seem satisfying and powerful. Nothing like hubby's Riva.

I did swap battery's with the Riva and found that, hubby's vision cartomiser is fine on both bat's, but my vision ego is airy on both bat's.....

Any advise?

[DiscoDes]

You have screwed the drip tip in fully and not just pushed it in?

The coil head is also screwed in properly?

[Dream (s)]

Yes very fully

[chrisjw]

Sounds like a duff vision Dream.......apparently you do get 'em from time to time

[Dream (s)]

I thought it may be that, but being a newbie I wasn't quite sure

[Dream (s)]

Jul 16, 2012 12:56:47 GMT DiscoDes said:

You have screwed the drip tip in fully and not just pushed it in?

The coil head is also screwed in properly?

Now your asking something I'm not sure of what it is exactly? lol Would that be the bottom of the cartomiser? If yes, I've noticed that when it's screwed in proplerly it's worse, but when it's very slightly loose it eases as little, but the airyness is still there :-[

[DiscoDes]

You say it is a Ego Vision, is it the one with the changeable coils like the inside of a Vivi Nova?

[Ellen]

Which vision ego are using Dream? The rebuildable one? Or the previous version?
You keep saying cartomiser, but I think you mean clearomiser?
The drip tip is at the top, the bit you puff on, on regular cartomisers you just push it on, but on a vision ego clearomiser, you push it on and screw it in...

[platinumvape]

I've seen this problem with some of the vision/ego4 tanks.

Some just don't work well. They're either too tight or too loose in their air flow.

I've seen this with some of the cheaper visions but also with more expensive from some of the big online suppliers.

I think the type of wick used makes a difference also, some seem to wick better than others. I've noticed a difference in how the coil is wrapped between suppliers as well. Some seem to have a couple of turns of wire on the wick so quite a small survice area of wick to heat, that may well make a difference.

PS, I'm no expert just what I've found recently.

PV

[DiscoDes]

Which one do you have?

This is a Vision

[DiscoDes]

This is the Vision Ego

[Dream (s)]

This is the kit I purchased the 900mah and yes Ellen your right, my mistake it is a cleoromiser not cartomiser, thankyou for realising

www.liberty-flights.co.uk/product.asp?id=180

[ciar]

I use the V3 vision ego clearomizers, with my ego-t 900mah battery, if you do them up too tight they won't work the light just flashes but nothing happens, just loosen them a bit and they should be fine...

one tip i found even though i use needle cap bottles, liquid still seems to get on top of the battery, i find cleaning it once a while during the day really helps, even though I am not sure how it gets on there it does

all in all though since buying the V3 i really haven't bad a bad time with em... hope you sort it out Dream (s)

[ciar]

Jul 16, 2012 13:15:13 GMT Dream (s) said:

This is the kit I purchased the 900mah and yes Ellen your right, my mistake it is a cleoromiser not cartomiser, thankyou for realising

www.liberty-flights.co.uk/product.asp?id=180

that's basically the same kit i am using except mine came from Jason.

[Dream (s)]

Ok, so it's the v3 I have. I dunno, but I'm comparing it to the Riva I purchased from Jason and that one vapes brilliantly, hang on I'm going to check which vision comes with Jasons Riva kit

As for screwing this one tight, when I do the light doesn't flash, wondering how come yours does?