Recent Posts

Dont say that Its been working nicley this afternoon set at 445 and with liquid in there I havent noticed any burnt flavor at all.

Yes it gives a 1 second burst then stops and shows 'no liquid' message.
I did a full 10 seconds or more until the message dissipated and it was obvious that it had stopped.
Did that at 500 and no marks on cotton.
I did after give it 5 short bursts of 1 second at 500 and it was a different story.



Seems to me like the limiting doesnt kick in for the first second and giving it 5 x 1 second bursts may bypass the limiting before it has chance to react.
I would really expect their to be less scorching at those lower temps.

OK you two, don't fall out trying to help me....I appreciate advice from both of you.

I havnt done a burn test yet robby . When I tried out the evic for the 1st time I had it set at 520 which was way too high(my experience of the SMY not working properly) and noticed that the cotton was getting scorched so turned it down to 420.
Have been using the D2 now as it was the one that was causing me concern with it not firing at the specified limits. So want to make sure it was working properly at the higher res that it will fire.(the SMY again, something was causing it to read the res wrong and everything was shot from there.)
I will vape this one dry and do a test just so I know what point it starts burning the cotton.
ATM I have it set at 445 and 40J on a the duel coil above that it is reading it at .09
Ill do them both once its dry and see if they are 1.) reading the res the same and 2.) too see if the cotton burns at the same point or not.

Took your advice VapingBad and things are looking up.
Thought about the spreading out and decided to try 4mm coils of .35 Ni 12 wraps each.



I dont know If this is exactly what you meant as the spacing between loops is closer



This is working better than the last set-up. I can see that pre-heat is a good thing to have as I need to wait for a second or so and then take a much steadier draw than I would on a kanthal set-up. It's starting to hit the spot though so thats good. Thanks.

I think the issue is not with the monster base, but the other base that a few have tried.
The only event that I have seen is one of the center pins snapping when it was being tightened up (which they do need).
I have had loads of separate parts to use with these and everything fits just fine.
Its a pretty good vape at around .7 -.8 and around the 30W mark.

Have to say having got the evic and the D2 at the begging of the week, the evic seems to be the better vape. The pulse effect is less noticable than the D2 and i think the temp limiting is smoother.
Still novice with TC so dont take that as gospel, but with them both set the same the evic wins for me.

Its the same with the standard goblin, you just need to get enough wick in the top half of the channels and it will prevent any leaks. Dont go overboard as you will 'choke' the wick when you screw the top on. After a few goes you'll have it sussed.