timmyds
New Member
Joined:September 2014
Posts: 1
Location:
Likes: 1
Recent Posts
Last Online Sept 18, 2014 2:36:22 GMT
|
Post by timmyds on Sept 15, 2014 23:50:23 GMT
#1 THANK YOU OP for posting this as when I searched this problem out, it directed me here so I knew what to look for.
For what it's worth, I found a shortcut I figured I would share as on my 1st mvp 2.0 I striggled getting the button back in. Sooo, just take off the bottom 4 screws by the charging ports. Using a VERY flat small screw driver or knife, carefully pry the glass up over the lcd display. It wont break, just start at one end you can get into, and pry up. Then the 2 buttons will just fall out. Then just slide out that end, and remove the 3 screws mentioned by OP, and solder port as mentioned. Slide back in, place buttons back, then press glass back down, there will be enough sticky swiggle to readhere itself. Viola~ all done in about 10 minutes.
|
|