Hi from Glasgow, a few questions...

[lobeydosser]

I'm not sure why I get condensation, but I usually get it when I am using my Bud clearomisers. It is usually quite bad until I have gone through the first 1/4 of the Bud, then it disappears. Probably takes that time before the top heats up a bit.

With clearos, if I get a condensation sound, I take it off, hold a tissue under it, about an inch away from the base, and gentle blow down through the clearo and blow out the centre tube.
It probably isn't condensation but actually drips from the coil going down the air tube.

Remember to clean any e-juice from the top of the battery regularly.
I use either a Cotton Bud or the corner of a Tissue.

Further to what I wrote above about not changing the heads and wicks of my clearos/tanks very often, tonight I did change the head of my Viva Nova Tank to one with a higher resistance, just to try it.
It has made a difference in that I don't have to sook so hard to get a decent mouthful of vapour.
Me thinks that my next order will include a couple of 5 X packs of spare heads and give all my tanks and clearos a wee christmas revamp!!!!

Like I have said elsewhere, I am learning all the time and it takes time and experimentation to work out what suits me the best.

[lobeydosser]

Nov 28, 2012 21:06:40 GMT andym said:

Hi cammy,have you found a Haggis and Neeps e juice yet?

I'm still looking for that, plus Mince & Tatties, Chicken Tikka Masala and Deep Fried Battered Mars Bar Juices.

Ken a Choochter canny live oan Irn Bru Flavour alone!!!!!

[andym]

I tend to use 2.8 ohm atty heads on the ZMAX and 2.4 ohms on the Lava tube.I usually rinse out the atty heads and tank every 2 or 3 refills.

[dizzi]

Nov 28, 2012 20:45:51 GMT Cammy said:

I've also noticed in the last day that my clearo is kinda squint, and moves ever so slightly when attached to the battery.

I've got one that does that Cammy, if you run your fingernail round the bottom of the tank where the plastic meets the metal, is there a gap on one side? I just push mine back together, making sure to push it in straight so as not to force the whole tank off the base!

[alanfinal]

Hi Cammy,welcome along