Vamo Volts

[brysoni23]

Evening,

Had the Vamo for 2 days but cant seem to get the Volts right for me so i want a little help.

I am using a Mini Nova rewicked yesterday at 2 ohms. The batts i have are Torchy 2000mah 18650's. (not sure if this makes a difference)

My 900mah ego and the mini nova the taste is good.

So all i was wanting to know is what is the output Volts of the 900mah so i can set it to the same on the Vamo and no difference in taste.

Cheers
R

[Ratfinkz]

Not sure - but you could try starting at lowest and taking a vape at every increment until you find your sweet spot. Might be easier to do that via VW? (goes up in 0.5 where as volt goes up in 0.1)

[robby]

I would use variable wattage and about 7 watts, see what that is like, may need a touch more. With variable wattage the resistance of the atty doesnt make a lot of difference then.

With the ego you arent going to get more than 4.2 volts, so maybe start at 3.9V and see how that is if you want to use VV

[brysoni23]

would re-wicking it to 2.8ohms make a difference?

[robby]

Feb 6, 2013 0:13:32 GMT brysoni23 said:

would re-wicking it to 2.8ohms make a difference?

Not if you are on variable wattage, you would have to bump the voltage up a bit on variable voltage though.

[Neil from Valley Vapes]

I had the same problem yesterday. Rewicked my nova to 2.0 tried it on my ego t it was fine put it on the lt it was bloody awful didnt matter what voltage it was on above 3.0V, Rewicked it again to 2.7 made sure there were no hotspots, coil all evenly spaced tried it again on my lt and it was spot on loads of vape and flavour.

[andy01424]

have you got it on mode 1 or 2,use mode 2........hold any of the small buttons down for 10secs til No2 appears[uou may get mode show hold again for mode 2] should vape better


mind you had that with the the vv ego batts i had nova was fine on one but orrible on other ,never did try it on the vamo, cannot now as dismantled the viv nova,and use aga t 's mostly now

[DiscoDes]

Variable wattage mode is a dream! As it does not matter what resitance (within reason) your coils are.

I use mine strating new coils at about 6 watts and as the coil ages I gradually increase the wattage to combat the gunking up once it no longer performs at 9w I recoil/rewick.