|
|
Post by Neil from Valley Vapes on Feb 9, 2013 22:10:22 GMT
Is there any way to stop the hotspot on the top of an rba between the wick and the positive post?
|
|
gillas
Senior Member
Joined:November 2012
Posts: 252 
Location:
Likes: 89
Recent Posts
Last Online Jul 17, 2020 17:44:01 GMT
|
Post by gillas on Feb 9, 2013 22:15:43 GMT
you are best trying to lean your wick toward the centre post to keep the wire as short as possible or failing that double the wire over at the top coil (twisted)
|
|
|
|
Post by Neil from Valley Vapes on Feb 9, 2013 22:17:18 GMT
yeah i have got it leaning over now so its only short i did try to double the wire over at the top but it didnt go to well so i gave up to try again tomorrow lol.
|
|
greendollar
Super Member
Joined:September 2012
Posts: 921
Location:
Likes: 355
Recent Posts
Last Online Dec 25, 2020 20:41:45 GMT
|
Post by greendollar on Feb 9, 2013 22:25:19 GMT
I found this method the best way of avoiding hotspots Neil
good luck
|
|
|
|
Post by Neil from Valley Vapes on Feb 9, 2013 22:34:38 GMT
I found this method the best way of avoiding hotspots Neil good luck Cool I watched that one, I will give it a whirl tomorrow. Just one silly question does it have to be kept upright at all times when it has juice in it? |
|
greendollar
Super Member
Joined:September 2012
Posts: 921
Location:
Likes: 355
Recent Posts
Last Online Dec 25, 2020 20:41:45 GMT
|
Post by greendollar on Feb 9, 2013 22:41:34 GMT
Nah , aslong as you don't turn it upside down you shouldn't make to much of a mess
also try not to pull the wire too tight especially the top one , just pinching it between the centre post nut is enough to get it to fire
|
|
