A full on guide i wrote up:
So you have just received your Beautiful Riva 1100 and now you want to test it out!!
Here we go....
Setting up your Riva 1100 for the first time step by step guide:
Unpack and get familiar with the goods:
2 x 1100mah Batteries (3 Clicks on/off)
1 x Vision Ego Standard Resistance Clearomizer
5 x Standard Resistance Cartomizers
1 x Cover Cone (Screws over the Cartomizer to make it look nicer)
1 x USB Charger
1 x 510 Drip Tip (Mouth piece for use with the Cartomizer)
1 x Carry Case
The above contents apply if you purchased it from:
www.vapeescape.co.uk others may differ.
Note:Batteries come partly charged so this is optional, I prefer to just charge them fully and get it over and done with.
Plug your charger into a usb port and charge your battery’s by screwing them into the charger (not too tight), you will see the light on the charger go from green too red (red meaning it's charging), once charging has finished it will go back to green (battery is now fully charged)
Now you have two fully charged batteries lets move onto the next part...
There is two ways to fill a Cartomizer....
Dripping method:
Condom method:
Most common is the Condom method
How to fill a Clearomizer:
If choosing to use a Cartomizer leave to rest for 15-20 minutes so the filler gets fully soaked (Some may say you can use it just after five minutes but I prefer to let it rest as long as possible, better to be safe than sorry)..... If it aint fully soaked you will get a burnt taste when you use it for the first time and that taste will not go away so the Cartomizer is now useless.
If choosing to use a Clearomizer leave to rest for five minutes so the inside parts (mainly the wicks) get fully soaked, you can speed this up a bit by shaking the Clearomizer around so the juice has fully touched all parts.
Now you have two fully charged batteries and a Cartomizer or Clearomizer fully juiced up.
Now to test out the Riva.....
Take hold of your Riva battery and press the button 3 times to power it up (3 times on and 3 times off) – (Lights flash blue when you do this)
Whatever you filled up with juice whether it be the Cartomizer or Clearomizer screw it onto the Riva battery (not too tight).
If you chose the Cartomizer put the Cone that was supplied with your Riva on top of the Cartomizer and screw on (not too tight) and then plug your Drip Tip (Mouth Piece) that was also supplied with your Riva into the top of the Cartomizer.
Almost there....
Now what I do when fitting a new Cartomizer or Clearomizer is to press the power button atleat 3-5 times for just 1 second a time just to get the heating element inside the Cartomizer/Clearomizer used to the liquid.
Once that is done you are ready to vape away.
When vaping I tend to hold power button for 1 second without dragging to let a bit of vape build up in the Cartomizer/Clearomizer and then drag nice and slowly and long (not hard dragging)
You have now had your first Riva 1100 vaping experience....ENJOY.
Hoped this helped.
Regards
Romelee