raid2506
Mod Maker
Diablo Rey
This is my Riva - There are many like it but this one is mine!
Joined:November 2012
Posts: 1,429
Location:
Likes: 987
Recent Posts
Last Online May 17, 2023 1:08:20 GMT
|
Post by raid2506 on Feb 12, 2013 23:54:42 GMT
It don't get no easier than this...
I just got some Hangsen RY4 the other day and the bottles have fine steel needle tips, not like the plastic drippers that I'm used to.
Anyway, pop the rubber stopper out of your carto
slip the needle all the way down the side of the wadding
squeeze till the wadding appears wet on top
job done!
It doesn't seem to matter that the needle only goes halfway down the carto, I'm still getting good fills.
|
|
pixiguru
Super Member
Quiz Master
Katie Potatie
Joined:July 2012
Posts: 1,141
Location:
Likes: 111
Recent Posts
Last Online Aug 27, 2018 15:08:11 GMT
|
Post by pixiguru on Feb 12, 2013 23:57:43 GMT
Becareful not to damage to coil with the needle I tried this with a proper ie non blunt needle didn't work but it was vg juice
|
|
raid2506
Mod Maker
Diablo Rey
This is my Riva - There are many like it but this one is mine!
Joined:November 2012
Posts: 1,429
Location:
Likes: 987
Recent Posts
Last Online May 17, 2023 1:08:20 GMT
|
Post by raid2506 on Feb 13, 2013 9:21:37 GMT
Well I have only tested it on 2 cartos from my parts bin so nothing lost if I kill one.
The needle is quite fine, only about 1.5 mm and on both cartos there is a natural gap where the wadding has been rolled.
This RY4 is thin as water so am guessing pure PG, if you (accidentaly) squeeze the bottle it shoots about 3 feet in the air :-[
|
|