Arry's tank or the Map tank

[shamreez]

Hi All.

I was planning to upgrade my clearo's to use a tank mod and I am in a little bit of dilemma

As the subject says should I get a MAP tank or an ARRY tank.

Both of them are available at moju republic for £18.50 (In fact I could see that the ARRY tank is available in some sites for as low as 14.50)

So if any of you use both could you please advice me.

(I know perpy has both but dont know if she has stated using the ARRY tank yet)

[VE Jason]

I use both Sham and they both do the same job to be honest.

There are more variants of the Arry Tank and they can usually be adapted by just buying some new plugs from him.

[ian]

Arry tank for clearomisers and Map tank for modded CE2 cartomisers Sham.So go for the Arry clearomiser tank

[shamreez]

Thanks ian..

So as far as performance goes there is hardly any difference ..

I mean any one of it better at handling leaks or all of it is based on luck

[ian]

Its all about getting a good seal Sham and not overfilling them.Even though capacity is stated at 5ml its far better to just add 4 and a bit.As long as you dont fill higher than the white cup of the clearo you should be fine.Alot of people do it wrong and blame the tank when infact they have not fitted the clearomiser properly, or have overfilled it and get leakage through the connector.Ive not had any problems at all with mine tbh regarding leakage.

[shamreez]

Thanks a lot ian..

Would now just wait for a few days to check out how the CE3 is happening (Is supposed to release today) and if that is great go for it else ARRY it is...

[Perpetua]

Deffo the Arry Tank Sham as Ian & Jason have said . . . it's a bit easier to change the clearo innards on them as well. Although I was very lucky as Ian very kindly did the gubbins for me on mine.

I've had no leaks on either of mine, performance is the same as well.

[roachieuk (aka eciggery2011)]

Why does myne leak when i put it in my box? this is the only woe for me when its on its fine but when i put it to rest when i want a change it leaks all in my box?

And im doing it right and only using half a tank so proberly around 2.5-3ml

[vereybowring]

I am going to throw a "grenade" of information into the thread and run.

Has anybody tried The Minus Tank from C9V since people over on Lisa's forum seem quite taken with it ?
*running*

[VE Jason]

Jun 6, 2011 14:35:58 GMT roachieuk (aka eciggery2011) said:

Why does myne leak when i put it in my box? this is the only woe for me when its on its fine but when i put it to rest when i want a change it leaks all in my box?

And im doing it right and only using half a tank so proberly around 2.5-3ml

My first Arry Tank leaked Jay, it turned out that the little silicone washer type thing was missing off the bottom of the Clearo.

I find that I get more flavour from the Carto tank to be honest, although I haven't used it enough to need to change the carto yet - which I believe can be a bit of a pain.

[roachieuk (aka eciggery2011)]

Ah cheers jason mate im not giveing up yet i shall beat it lol.

[Perpetua]

Lol, no I haven't tried the Minus Tank Verey . . . but it looks to all intents and purposes the same as the Arry Tank - but a little pricer.

Isn't it just a variation on a theme, or am I missing something?

[roachieuk (aka eciggery2011)]

Hmm it looks thinner in diameter if you look at the video on the site it does look slightly thinner?

Pehaps thats why its called the minus tank?

[vereybowring]

I think it's a materials thing as well TMT is made from relatively expensive flight grade plastics that aircraft windows are made from, I believe the endcaps are made from delrin.
What's the Arry and map made from ?

*EDIT the tube is lexan, ends delrin

[Perpetua]

Jun 6, 2011 15:40:08 GMT vereybowring said:

What's the Arry and map made from ?

Clear stuff and black stuff as far as I know Verey.

Being serious, the end caps on both the Map/Arry are made from Delrin . . . the perspex tube, is just that to me.