I- Clear 16 - Help

[sammy13]

I was just about to buy some of these but they are available in 1.5 or 2.0 ohm.
I am using an ego battery - basic, doesn't change voltage or watts or anything which ohm do I need?

[Karma]

I'd probably go for the 2 oHm

[Jen]

In general, 1.5 for baccy flavours, 2+ for sweet

[Deleted]

I'd probably go for the 2.0 too, the 1.5 might make everything taste burnt.

[blakey]

Tough one- the ego is regulated at 3.3v so it may not have enough ooomph to run a 2ohm coil but if you like a not so strong vape then a 2ohm is ideal
the 1.5 will perform very well at 3.3v but the circuitry in the ego may not be strong enough to handle the power drain and you could blow the switch. I haven't managed to blow a switch myself at 1.5ohms but I have read about a few people that have.

Personally I would risk the 1.5 but I couldn't advise you to do the same

[Cheralynn]

I've got both ohms and never had problems with either on ego batteries.

[sammy13]

Thanks guys as we had a split I looked around different shops and a few advised to get the 1.5 , so I went with that I hope I don't blow a switch though whatever it is it sounds painful. If I'd have read that first I would have gone for the 2.

[alansi]

Jul 20, 2013 9:47:08 GMT sammy13 said:

I was just about to buy some of these but they are available in 1.5 or 2.0 ohm.
I am using an ego battery - basic, doesn't change voltage or watts or anything which ohm do I need?

Look at Innokin. They wrote:

Note: iClear 16 2.0 ohm is for VV/VW device
iClear 16 1.5 ohm is for non-vv devices, such as eGo, lea, leo, etc.

thereal cmac review