Vamo 3 question

[hissie]

Hello.

I know how to do the vv but haven't a clue how to work the vw.

Also, does the vw mean I can use sr boge & lr boge to the same effect?

[OneDay]

Hi Hissie

Yes, the beauty of VW is that if you find that you like vaping a particular juice at, say, 7 watts then you can set your device at 7 and whatever you put on top of it you should get the same vape.

[hissie]

Thanks oneday.

I don't know how to get it to work lol.

Also, never vaped in watts before, so wouldn't know what I would like. I like 4.7v when vaping tho'.

[OneDay]

4.7v on what resistance carto Hissie?

[OneDay]

Press the big button five times rapidly to turn it On after changing the battery. Same again to turn it Off.
Hold the left or right button down for at least 10 seconds until the display says No2. If you do this again, it will say No1. You want it to say No2.
Press and release the left or right buttons to decrease or increase the Wattage. Start at around 6.0W and work your way up to whatever suits your taste.
Holding down the left button for a couple of seconds will show the remaining voltage in the battery.
Holding down the right button for a few seconds will show the resistance of whatever atomiser/carto/clearo you have on top.
Hold down both buttons to toggle between Variable Voltage and Variable Wattage

[chykensa]

hissie - the beauty of Variable Wattage is that regardless of what you screw into the top, the Vamo will do the maths and always reproduce the same power to the coil. If you use a Low Resistance carto, for example, at 6.5w and like the taste/throat hit/taste, leave the Vamo as it is, and then screw in a Protank with a 2.5ohm coil; the Vamo will automatically adjust so that you get exactly the same vape as you did with the LR carto.
If you stick with VV, you will have to readjust each time you change what's in the top - VW, it does it for you - simples!

[gazza]

Hi, I'm not sure but I think oneday's instructions may be for the vamo v2 where you have to select the AVG mode(no1) or the RMS mode(no2), the vamo v3 only has RMS mode so there is nothing to select.

 Vamo V3 Functions:


•5 Button clicks on the larger “fire” turns the Vamo V3 on or off


•Output Voltage from 3.0 volts to 6.0 volts. Adjusting the working volts by 0.1 volt each time by pressing “+”(right button)  or ”-” (left button) buttons.


•Output power from 3 watts to 15 watts. Adjusting the working power by 0.5 watts each time by pressing “+”(R) or ”-”(L) buttons.


•Pressing “+”(R) button for more than 3 seconds, the OLED screen will display the present working resistance of your tank coils.


•Pressing “-”(L) button for more than 3 seconds, the OLED screen will display the present remaining battery volts / charge.


•Pressing both “+” and “-” buttons together for 10 seconds will switch to Volts or Wattage output mode.

Hope this is of help.
 

[hissie]

Thanks y'all.

I use LR boges oneday. However, I do have a few SR boges aswell. So, using the VW will allow me to use those aswell


Trying out changing voltage to wattage..think I'm going to need some practice lol

[chykensa]

On VW, you don't need to do anything apart from swop one carto for the other - the electronics will recalculate and give you the same vape with either - clever, eh?