Itaste MVP V2.0 vapour probs

[bro]

Jan 20, 2014 21:51:45 GMT @freefromsmoking said:

Jan 20, 2014 21:38:57 GMT bro said:

got a multimeter here,unsure of what to put it on

Set the MVP to, say 4 volts then set the multimeter to a low DC voltage range (to read about 4 volts), touch the red lead to the pin in the centre of the 510 connector and the black lead to the threaded part of the 510 connector and ask your partner/friend to press the power button. The multimeter should read close to 4 volts (there will be a small voltage drop within the multimeter leads). If the voltage reading is much less then the MVP ain't producing the voltage that it should.

the reading was 4.28 when i set the multimeter to 20 dcv

[bro]

Jan 20, 2014 21:51:24 GMT keepitgoin said:

Try taking off the head, remove rubber cap, give it a wash and Dry Burn and see if the coils light up bro, maybe the coils are dead, my iClear 30 hits hard, but there could be dud ones. Post back here if you don't get my drift on Dry Burning.

getting vapour off it mate,just muted

[keepitgoin]

What Juice are you Vaping?? Have you filled the iClear 30 up (or almost) to the full line??

[Greg]

Daft question but seen as you only just got the MVP did you charge it up before you got it, is the fire button turning green when you fire it ?

[Deleted]

Jan 20, 2014 21:54:48 GMT bro said:

Jan 20, 2014 21:51:45 GMT @freefromsmoking said:

Set the MVP to, say 4 volts then set the multimeter to a low DC voltage range (to read about 4 volts), touch the red lead to the pin in the centre of the 510 connector and the black lead to the threaded part of the 510 connector and ask your partner/friend to press the power button. The multimeter should read close to 4 volts (there will be a small voltage drop within the multimeter leads). If the voltage reading is much less then the MVP ain't producing the voltage that it should.

the reading was 4.28 when i set the multimeter to 20 dcv

If the MVP was set for 4 volts then it is producing more than the required voltage ...  allowing for any multimeter error the MVP doesn't seem to be the problem  .... could just be a dodgy iclear head  ...  is the draw airy enough or is it very tight?

[bro]

keepitgoing

18mg dekang which is ok on my v3

gregb

yep and yep

freefromsmoking

seems a little to airy but got a airflow controller on the way

[keepitgoin]

Didn't know about airflow controllers for an iClear 30. Have you got any spare Heads? Might be worth changing the head??

[bro]

pmed myepack and he said it could be faulty but just take it apart and put it back together tight(was already) now it vapes fine,sometimes the simple things work

keepitgoin,just ordered one with my eco incase i needed in thee future,arrived today so may fire up my agat+ aswell

[bro]

right after all that was finally started,i was using it today and the button goes on yellow,so when i put it on charge straight away the button turns green ?,,,,,,,,do i have to wait till it goes red to charge

[lal]

The light goes out when it's charged.

[bro]

thanks lal,guess i should read the manual more carefully