aga-t2 wicking

[vapeguy]

I'm only getting half way down a tank before I'm getting wicking problems on a full tank I'm having no issues help needed plz

[jcol]

Hi vapeguy its been a while since i used my aga t2 but i presume its not wicking properly?
Is the wick slightly loose in the hole? if its too tight it may stop the juice flowing
Also when you rolled the wick, did you leave a small hole in the centre? if the wick was rolled too toght, this may also stop the juice flowing.
And i find cutting the bottom of the wick at an angle help feed juice better. so instead of the bottom of the wick looking like I_I it looks like I/ if you see what i am trying to say lol

[andy01424]

if its too tight open a safety pin and push needle end through it,that will help,also what i have been doing if you have a bit of silica wick roll some inside it and leave a tail at the bottom of the wick

[giles]

I like to have a little cotton wrapped round my wick like this guy.