THE focal cig nemi

[decoy]

May 5, 2014 2:52:35 GMT enjay said:

May 5, 2014 2:36:52 GMT decoy said:

so i just have to find a good spring 
now i must have one in a torch or something lol
oh i did find some donut coils as well im gona order some at end of the month for a giggle

I wonder if you can buy the hcigar springs on their own, they're a lot stiffer than the ones in the focal job.

found an old car ciggy lighter and nicked the spring outa that it fits and works with a bit of messing about with pliers, left the tin can in and im v happy bunny (did put some copper slip grease on the tincan bit) 

[enjay]

May 5, 2014 2:59:01 GMT decoy said:

May 5, 2014 2:52:35 GMT enjay said:

I wonder if you can buy the hcigar springs on their own, they're a lot stiffer than the ones in the focal job.

found an old car ciggy lighter and nicked the spring outa that it fits and works with a bit of messing about with pliers, left the tin can in and im v happy bunny (did put some copper slip grease on the tincan bit) 

I stuck that little spring in the hcigar nemmy and the switch is now superb, I'll need to find something similar for the focal one.

Not to keen on the copper grease, I think it'll just collect dirt and foul up the switch. Mine often gets dirty as it is if I keep it in my pocket.

[decoy]

May 5, 2014 3:05:37 GMT enjay said:

May 5, 2014 2:59:01 GMT decoy said:

found an old car ciggy lighter and nicked the spring outa that it fits and works with a bit of messing about with pliers, left the tin can in and im v happy bunny (did put some copper slip grease on the tincan bit) 

I stuck that little spring in the hcigar nemmy and the switch is now superb, I'll need to find something similar for the focal one.

Not to keen on the copper grease, I think it'll just collect dirt and foul up the switch. Mine often gets dirty as it is if I keep it in my pocket.

good point on the grease but ill leave it as is for now and sort out the grease when i get the copper sheet
but get an old pop out car lighter the spring is pretty good and can prob get one for free from the scrappy

[enjay]

May 5, 2014 3:29:27 GMT decoy said:

good point on the grease but ill leave it as is for now and sort out the grease when i get the copper sheet
but get an old pop out car lighter the spring is pretty good and can prob get one for free from the scrappy

I've just chopped a little section off the end of a 2mm drill bit, it's a much better fitting pin

[decoy]

May 5, 2014 4:05:45 GMT enjay said:

May 5, 2014 3:29:27 GMT decoy said:

good point on the grease but ill leave it as is for now and sort out the grease when i get the copper sheet
but get an old pop out car lighter the spring is pretty good and can prob get one for free from the scrappy

I've just chopped a little section off the end of a 2mm drill bit, it's a much better fitting pin

dam good idea that so much so i copied it but tried a little veriation

seems to have gotten rid of all cruchyness
all i did was cut it to same lenght as center post  and grind a flat on it so it fit if that makes sence

[enjay]

decoy I jammed mine in and it works fine, I know why you flattened a side though, I seen where it gets tight but yeh, works fine so left mine as is.

[decoy]

it runs the full length of the center post now been trying it for a day now and its like a diff mod