Direct dripping, you could've warned me!

[enjay]

Jun 6, 2014 23:43:37 GMT Dan said:

Jun 6, 2014 23:40:55 GMT ronaldo said:

if the cloud wasn't big take a deeper draw

Now now fella, sounds like her throat may not take a deeper draw!!

For proper clouds you need 0.6 wire and silly low ohms.. (I've seen what 0.02ohms can produce!)

Saying that, you'll want 100vg juice too!

28G parallel is way better but I went up from 0.2 ohms to 0.5 and got bigger clouds lol, vaping a 40/60 blend at 24mg. Booya!

[Dan]

Jun 6, 2014 23:52:38 GMT enjay said:

Jun 6, 2014 23:43:37 GMT Dan said:

Now now fella, sounds like her throat may not take a deeper draw!!

For proper clouds you need 0.6 wire and silly low ohms.. (I've seen what 0.02ohms can produce!)

Saying that, you'll want 100vg juice too!

28G parallel is way better but I went up from 0.2 ohms to 0.5 and got bigger clouds lol, vaping a 40/60 blend at 24mg. Booya!

Running a parallel takes more battery power though.. not only that, but it spreads the heat too..

you're gonna take you're head off with 24mg!

lowest I've gone is 0.7 as I don't own a mech atm.. will be getting another nemesis soon though to hybridise the 3d and go nuts..

looking at another igo with pmma topcap later down the line..

[OneDay]

[enjay]

Jun 6, 2014 23:58:08 GMT Dan said:

Jun 6, 2014 23:52:38 GMT enjay said:

28G parallel is way better but I went up from 0.2 ohms to 0.5 and got bigger clouds lol, vaping a 40/60 blend at 24mg. Booya!

Running a parallel takes more battery power though.. not only that, but it spreads the heat too..

you're gonna take you're head off with 24mg!

lowest I've gone is 0.7 as I don't own a mech atm.. will be getting another nemesis soon though to hybridise the 3d and go nuts..

looking at another igo with pmma topcap later down the line..

I'm mech only with sony vtc4's, also went from smoking over 50 a day so the nic is fine, I take less hits with the dripper though but vape the 24 all day long in the kfl+ with a 1 ohm coil.

I also use the toffee in the drippers and caramel blend in the kfl+, I find the caramel is to hard in the drippers even though it's the same blend and nic strength, I'm finding the actual flavouring can make a difference to the hit.

I'm also finding that the right build even at low ohms can be seriously pleasant and not to hot or harsh at all. Still learning though, going to look for some good info on how to get the balance just right between the coil, wick and air.

[enjay]

Jun 7, 2014 0:04:09 GMT OneDay said:

I reckon the last thing that guy says before he dies is gonna be "watch this!"

[xrayspecs]

Drippers are my favourite way of vaping at the moment but if I've been using a clearomiser at work all day the it usually takes my throat about ten minutes to get back into dripping mode once I get home.
I find rebuildables in general are a bit harsher on the throat than clearomisers plus I tend to run drippers about 1v higher than other atomisers.

[joojitsoo]

Jun 7, 2014 0:04:09 GMT OneDay said:

Hahaha what a plonker