iTaste 134 arrived today!

[doctorjellybean]

After my disappointment with the iTaste SVD, I ordered the iTaste 134 which arrived earlier today.

The batteries are charging, new Kanger Protank II especially purchased for the 134 fitted with a Kanger Airflow Control Valve V2 filled and screwed on.

Before I insert a battery and start vaping, any tips and tricks?

[Steve (VapeStorm)]

Switch device on

[dalealan]

Same as most vw's. Start low and build up a bit at a time, any burnt taste and back it down a notch. Oh and don't tighten the atty down too tight... And don't wash colours with whites

[Steve (VapeStorm)]

Dont eat yellow snow

[ruffdog]

Jul 29, 2014 21:29:30 GMT Steve (VapeStorm) said:

Dont eat yellow snow

Coz that's where the husky's go !!

[dalealan]

Always wear clean underpants and look both ways before you cross

[ruffdog]

Don't put battery in wrong way round like the svd instructions or it won't do anything lol.

[paulymeatballs]

Wanted one of these for ages. The prices have come down to a reasonable level now. The only thing that gives me pause is that narrow beauty ring. great for 19mm clearos but doesn't look so good with larger atties.

[clairea]

Jul 29, 2014 21:27:10 GMT Steve (VapeStorm) said:

Switch device on

that's a good tip, not all switch on automatically like i thought ha ha

[ruffdog]

Jul 29, 2014 22:35:57 GMT clairea said:

Jul 29, 2014 21:27:10 GMT Steve (VapeStorm) said:

Switch device on

that's a good tip, not all switch on automatically like i thought ha ha

I have so done that when changing batteries. Mod lights up like a Xmas tree when you insert battery, then sit there puzzled as to why it won't fire. Then in desperation you repeatedly hit the button and bingo! Damn thing was off all along. 
The Vamo even says welcome!! 
The svd goes into locked mode after a battery change and 1st switch on which I find a little niggling. 

Ruffie. 

[hijack]

Jul 30, 2014 0:15:04 GMT ruffdog said:

The svd goes into locked mode after a battery change and 1st switch on which I find a little niggling. 

Ruffie. 

Took me a whole day to get the SVD out of lock mode. I had to get help from a forum to figure it out.

The instrutions say hold down the buttons for 5 secs, but they don't say keep held down until after it displays res/power.

Anyway back to the OP, good luck with the 134, they look well made even if they are on the large side.

As has been said start around 7 watts and gradually turn it up till you get a good vape, back it off if it starts burning.

[andy01424]

by a 2nd one ,so no uneven muscle build up