filling a Pt3

[winnietyson]

I need advice on how to fill the Pt3 without getting juice all over my fingers!! It vapes beautifully but I'm losing juice with every fill!!
Any advice would be gratefully received
thanks

[ruffdog]

Just down the side . erm....... Make sure glass is all screwed in properly and then flill down the inside edge up to the cross bar / support.
Then screw back together and do about 4 dry vapes ( is. Not firing, just priming). Then start low volts / watts and go up until too hot or a "bitt  off " then back off a bit and enjoy.

Me, >>> 7w, 50/50 custard on protank 3, 1.9 ohm, rayon wick

Ruffie

[dalealan]

As ruffdog said. You shouldn't be getting liquid on your fingers. There's a bar going across when you take the base off, put the bottle needle or top so it goes underneath them then fill it to below the chimney section and screw the base back on and the jobs a good un.

[prr]

dalealan, nice reply (can't believe you're being sensible)

[dalealan]

Aug 11, 2014 22:21:49 GMT prr said:

dalealan, nice reply (can't believe you're being sensible)

It won't last prr 

[chrisintheuk]

Had one of these for ages, used it once and never again, leaks all the time, gurgles all the time, frustrating atty

[chykensa]

MPTs are great little atties, if you ensure that the fill is down the side and not down the centre tube. Also, make sure that the attie head is screwed firmly into the base, and that the little white silicone cap is firmly down over the 'chimney' before reassembling, you should have no leakage whatsoever.

[beetle]

You could also try using syringes with a blunt needle to transfer juice from bottle to tank. Just pop off the tip of the juice bottle for easy access and away you go. I use them when I get thick juices that come in stubby-nosed bottles and afterwards just rinse them out with warm water. They are also handy for measuring out the same exact amount of juice every time.

[PinkyPuff]

Hope this helps. :)This is for protank,but should be same for protank 3.I think

[djs]

Any size of Protank is awkward to fill with the fat tips they put on some bottles.

Either swap the tip for a thin one, or get a few needle bottles.