Possible use for a dripper?

[jevans]

If this has been covered before, I apologise!

Not really sure what a "Dripper" is, but understand it only needs a few drops to work.

So I was wondering if one would be any good for testing my new mixes to check for maturity.

Jim

[Tom]

you're best bet is probably a 306 bridged atomizer.

a RDA dripper needs coils building in it by you.

a 306 comes as it is and you just need the atty and a compatible drip tip.

www.ivapour-elixir.co.uk/atomisers/low-resistance-atomisers/lr306-atomiser-2ohm.html

[jevans]

Tom
Ha! Not only has it been thought of before, but there is a vid about it!!

Many thanks for the info.

Jim

[Tom]

no problem jevans

its what i use for flavour testing too

[jevans]

Tom
Is it possible to re-coil the LR306 + will I need an adaptor to fit my 510 (where my Kanger tanks screw in)?
Does it come with a mouth piece.
This is something I've not played with before.

[Tom]

Nov 10, 2014 14:14:23 GMT jevans said:

Tom
Is it possible to re-coil the LR306 + will I need an adaptor to fit my 510 (where my Kanger tanks screw in)?
Does it come with a mouth piece.
This is something I've not played with before.

It isn't re-wick or re-wireable to my knowledge. They last a pretty long time though - especially if your only using it for testing.

It will fit your 510 (where your kanger screws in)

you will need a specific mouthpiece.

the link i provided before you can pick the atty and then the mouthpiece.

this is the atty and also the drip tip needed together www.smokerainbow.com/bauway-lr306-bridged-atomizer-blue/

they are also a great place to order a load of very cheap samples when trying out liquids

[jevans]

Tom
Once again you've come up with the goods!
Many thanks

Jim

[jevans]

Tom
I've had the Bauway atomiser a few days now and am very pleased with it.
The flavours really come out.
After reading reddragon 's thread on the "Magma" I've been an gone an ordered one, the "Bauway" looked a bit silly on my "Hammer"!
Many thanks for your advice Tom.

Jim

[chykensa]

jevans- excellent choice for a first dripper. There are loads of videos around on building the coil(s) on a Magma, the best thing would be to start off in single coil mode to get used to it. You can always progress to dual coil builds in due course, but you will need to check that your batteries are up to the job as dual coils are usually lower ohm.
I have a Magma which powers along at 1.2 ohms, but once I get my mitts on some thicker wire I will be dropping that to 1ohm dead to see what the difference is!

[reddragon]

Haha jevans nice to see the AAEC wallet emptying effect in full flow. Hope you enjoy the magma

[aliscampbell]

This thread was really helpful when I got my Magma review and recoild of the magma

[jevans]

chykensa
Thanks for the advice Andy, Initially I will be single coil at 2 Ohms.

[jevans]

aliscampbell
Thanks for the link, that will give me a good start.

Jim

[jevans]

reddragon
Not your fault, it was more the other comments that persuaded me!
Thanks for initiating the thread.

Jim