another naughty nautilis

[shez]

Oh dear just as I thought I'd got everything sorted!

When unscrewing the naughty the coil was coming away with the bottom cap (don't know techie terms). Centre pin thingy of coil fell out. Managed to put the thing back together but not working. Any suggestions? Should I try a new coil? Current coil only a few days old.

Also not showing a resistance on the Vapourshark.

[brummiematt]

hi shez
im no expert, i have only just started using the aspire tanks myself, so far i havnt had any issues with taking them apart. i just hold it up side down and unscrew the bottom section ( which at the time is on top ) leaving the tank and juice,then i replace coil if needed, then screw it back on. might pay to give it a clean out then try with the coil again. silly as it may seem is the air control in a right position

[Greg]

If the coil centre pin came right out then it's likely you've lost the connection to,the coil when replacing the pin. best to install a new coil

[chrish10]

When you take the pin out you should see 1 wire that needs to be wedged between the pin and the rubber seal.It sounds like you have pushed the wire up the coil when re inserting the pin.

[DiscoDes]

You need to screw the coil section INTO THE BASE FIRST not into the "chimney" in the tank. I think you may think it's the other way around?

[shez]

Thanks all I'll give it a go tomorrow when I can empty the tank into my other nautilus rather than over my hands like earlier.