Newest creation

[crystal]

Latest box mod with a DNA30 in a Hammond 1590G box

Didn't really need the USB port because of magnets in the lid, I decided to use them instead of the screws after cutting the slot.

A little neater than my last attempt with the wiring

[igual]

Looking good,what cradle did you use for the board?

[crystal]

igual got it from shapeways with the usb, had to cut a little bit away so the ribbon cable fitted without creasing up.

[Deleted]

Looks great crystal soldering/wiring was something I struggled with, looks like you've been practicing

[crystal]

Mar 9, 2015 6:57:57 GMT @scooby said:

Looks great crystal soldering/wiring was something I struggled with, looks like you've been practicing

You wouldn't have said "been practicing" if you'd seen me yesterday morning @scooby, the power down button fell off when I soldered the wires to it. Tried sticking it back but glue got inside. Then the solder broke off leaving the wires to it a little short  .

I had to add two short piece of wire to the existing ones, thank GOD for heat shrink tubing.

Ended up using epoxy putty so the button didn't get glued up, solid as a rock and it works now. The air was a touch blue until I remembered the putty.

Learn by my mistakes is how I see it.

[vicuk]

have you made a nod with MOSFET ? if you have what are the best ones to use ? all the best vic ps where did you get them from ?

[letsavit]

Nice job mate, love the colour . Metallic?

[crystal]

Mar 9, 2015 11:43:50 GMT vicuk said:

have you made a nod with MOSFET ? if you have what are the best ones to use ? all the best vic ps where did you get them from ?

vicuk  I've not made a mod with a MOSFET, I don't really know too much about electronics, only what I've read up on, maybe in the future I will but for now I'm quite happy with regulated mods.

The box was from here. The rest I got from modmaker except the up/down tactile switches which were from amazon.

Chipset & USB charge boards from fasttech, cradles from shapeways.

[crystal]

Mar 9, 2015 22:57:00 GMT letsavit said:

Nice job mate, love the colour . Metallic?

Thanks letsavit picked the paint up from local BMS, primer, paint and laquer, that was the most expensive part.

[vicuk]

thanks for your help crystal I just hope the ones I make are as good as yours all the best vic

[VapingBad]

Nice job crystal

[crystal]

Mar 10, 2015 19:04:39 GMT vicuk said:

thanks for your help crystal I just hope the ones I make are as good as yours all the best vic

I'm sure you will do a good job vicuk

Best advice I could give is to take your time.

Good luck

[crystal]

Thank you VapingBad