Jammed attie!

[Tom]

good luck mr chykensa!

[VapingBad]

You could just try the budget vacuum system Andy and hold it upside-down and suck with a drip tip that has a good seal for all your life is worth while unscrewing it.

If one with the screw underneath and air inlet on the side (must be to make sense) block the air inlet while trying to create a vacuum.

[monty]

If nothing else works you might try www.ebay.co.uk/itm/NEW-10-or-30pc-Diamond-Rotary-Dremel-Burr-Drill-Engraving-Craft-Bits-Set-UK-/290707263214?pt=LH_DefaultDomain_3&var=&hash=item43af80ceee they'll fit in a regular drill.

[Deleted]

Maybe this a dumb question but have you not tried loosening it with vg?

Or is that mega dumb....vg, marigolds and some hot water

Magneto can be salvaged - just get a new top cap - www.bargainvapour.com/Smok_Magneto_Ego__510_Head/p1274299_10905129.aspx

Don't know about the atty

[drunkenbum]

Did you get it free chykensa?

[markm]

If there is a gap, I assume there is if you can see what's causing the jam,
Then you may be able to get some card or thin plastic sheet from packaging
Slide it under the grub screw to hold it up while you unscrew the atty.

[chykensa]

markm- haven't had much time to play around with it TBH, but yes there is a gap. I'm not sure if the grubscrew has dropped or has unwound itself but it is definitely jammed in the air groove.
I'm going to attack it with a vengeance tomorrow morning, I'll report back once I've freed it (how's that for optimism!).

[decoy]

Mar 30, 2015 19:14:42 GMT chykensa said:

markm- haven't had much time to play around with it TBH, but yes there is a gap. I'm not sure if the grubscrew has dropped or has unwound itself but it is definitely jammed in the air groove.
I'm going to attack it with a vengeance tomorrow morning, I'll report back once I've freed it (how's that for optimism!).

i have images running trow my head