Car box mod holder

[lairey]

Here's my newly cobbled together mod holder

[Greg]

May 5, 2015 18:13:23 GMT lairey said:

Here's my newly cobbled together mod holder

Oh come on they're not even colour coordinated 

[Deleted]

Did you say mod holder or loo rolls?

[chykensa]

Thanks Greg, but I don't have a cup holder anywhere, although I am going to research them on eBay. I drive a VW T4 Transporter, and although there are loads of storage cubby holes, none of them are the right size for my mod(s) - Smok M65 and MVP3. Might have to do the lairey trick with some foam instead!

[Deleted]

Don't you have a young feller as a van drivers mate?

He'll have 2 hands

[lairey]

May 5, 2015 18:20:12 GMT Greg said:

May 5, 2015 18:13:23 GMT lairey said:

Here's my newly cobbled together mod holder

Oh come on they're not even colour coordinated  

Hey, it works... much better than the chopped in half loo roll that was wedged in there earlier today! 

[drunkenbum]

My new car has a nice convenient cup holder in the dash that's perfect, either going to modify the poundland doo dah or make something to slot in there with a shaped hole for my mod. Needs to look tidy though as I have a bit of ocd when it comes to things like this

[Deleted]

Have you seen a Rover 75 cup holder?

[dagl]

Waddabout a short bit of pipe insulation?



IIRC Montana 's a plumber he might be able to advise sizes....

[VapingBad]

I made one from oogoo, but too big, gets used all the time as a desk mod holder, and some rings to block the air inlets and prevent leaks. Must get round to making another for the car.

[chykensa]

May 5, 2015 18:35:41 GMT kreed said:

Don't you have a young feller as a van drivers mate?

He'll have 2 hands

Nope, drive solo the vast majority of the time. Although my mod sit in my hand most of the time, I like to put it down when manouevring, and I have some that non-slip rubber matting on the dash which holds it, but on its side. I would like to be able to stand it up somewhere to avoid leaks

[Deleted]

Ditto chykensa

Exact same situation.

I took 2 mods with me today.........that was fun

[drunkenbum]

What about gluing one of those jwraps holders to the dash or another flat area chykensa or something similar?

[trollminer]

Maybe some one could make some moulded plastic clips that clip on to the dash / air vent so they can be taken between vehicles ?

[chykensa]

I'm wondering if I can fashion something onto a couple of blank switch panels on my dash just left of the clocks. Just need to find a good sturdy cup holder.

Having said that, I'm half tempted to try a gurt big square of velcro on the side of my mod - would be great to slap the mod onto the same area and simply stick it there, as if by magic!