Car box mod holder

[Deleted]

Sorry if you're reading this expecting me to have a solution

I'm looking for one.

Cup holders are rubbish..............and putting a box mod in a cup in a cup holder will still make it tip or rattle.

Is there a solution?

What do you guys do?

I'm getting very good at driving with one hand 

[Ron]

Velcro stuck on the panel and the mod

[glen]

May 5, 2015 12:49:49 GMT Ron said:

Velcro stuck on the panel and the mod

Have you patented this idea, If not, Its the dragons den for me lol

[Greg]

Any good, sure I've seen then in the UK / eBay

www.provape.com/CupVape-Cup-Holder-for-electronic-cigarette-p/cupholder2.htm

[Deleted]

I did think of that..............but then realised I don't have a single flat usable surface in my car within arms reach

[ausfost]

one old cup, one small can of expanding foam, knife to cut desired size hole in foam jobs a "good un" plasti-cote spray to finish it off posh like.
or put a blank in the cup which is a bit bigger than your mod before spraying foam to get nice clean finish

[lairey]

I've just cut a loo roll in half and squished both halves into the little well by the handle on the door. This seems to be stopping my mods from falling over when driving

[Deleted]

May 5, 2015 12:56:22 GMT Greg said:

Any good, sure I've seen then in the UK / eBay

www.provape.com/CupVape-Cup-Holder-for-electronic-cigarette-p/cupholder2.htm

Nearly..........maybe a box mod version of that ......that fits in a cup holder would work.

[Deleted]

lol.....loving some of the answers.............but it's all a bit Blue Peter isn't it?

I'm amazed there isn't something around that does the job......as intended.

[lairey]

Actually, reading this thread has inspired me to get more creative. I have just taken some foam type packaging that comes in sheets, about 1cm thick and cut a section long enough to wrap around my mod, not too snug that it will make it tough to pull it out and about 3cm deep. Taped it up and did a second one for my Smowell. The 2 of these fit perfectly in the door well Blue Peter, eat your heart out!

[Deleted]

<sigh>

I can see the only solution is to do something similar

[drunkenbum]

Poundland do a phone holder that slots in the cupholder. I think with a bit of moddification they would be perfect. I think I'll do one and post the result

[Deleted]

May 5, 2015 14:06:24 GMT drunkenbum said:

Poundland do a phone holder that slots in the cupholder. I think with a bit of moddification they would be perfect. I think I'll do one and post the result

Go for it drunkenbum

Can't wait to see 

[drunkenbum]

I'm pretty sure I've got one knocking around somewhere But for the life of me I can't think where. If I can't find it then it's a trip to poundland tomorrow. I was thinking about this problem a while back but never solved it. This thread has refreshed it now so it has to be done

[Deleted]

hmmm......somewhere too I have a phone holder for the car.

One of the ones that slots into the air vents.

Can't remember if it has a bottom shelf on it.

If I'm trying to hang a Sigelei 100w plus.....with the BIG magma on it............it's going to need to be supported from underneath too.