Subtank Plus prize from Gearbest

[MrDJ]

left it for 30 minutes, bumped the i50 upto 30 watt. couple of quick bursts and then back down to 21 watt and its cleared.

[phatfil]

fwiw i soaked mine for a few hours to clean minus the occ coil assembly, dried and then filled with juice and stood for a hour while i was busy, when i took a puff, no off taste, tho the lemon sherbert juice is strong in flavour?

[Q]

I've had no strange tastes at all, only used the ½ohm OCC, not primed it, just filled the tank and away I went, and I can empty the tank without any bother as well.

I love them, far more flavour than I'm used to and the airflow (wide open) is spot on.

I've ordered a couple of minis from FT hoping for more of the same

[Ripshod]

Sometimes a new head will taste of er........ cotton. Depends where the cotton is from but it isn't a problem, just vape through it.

[Deleted]

Top Tip for the OCC heads, don't vape anything with, custard, strawberry, coffee, pear drops or cream, if you do that IMO and in my experience you're coil will only last 24 hrs ( give or take ) before its clogged up and needs changing. I've ran out of SB MM and I'm now finding that even after THREE days the coil is still very good.

[Deleted]

I'm very used to the taste of new cotton.....but this was a bit different.

It's gone now.....didn't last long.

On another note.........the 0.5 OCC head is superb.

And now that I know it's rebuildable quite easily I'm a very happy cookie.

[sydsut]

My Subtank plus prize has finally arrived, took a while but well worth it. Checked Kangertech site and confirmed it is the genuine article. Some good news about Gearbest for a change. Will play around with it for a few hours to check it out.

[Deleted]

I bet you love it sydsut

I'm very pleased with mine........wasn't sure I'd get on with it.......and the rba deck needs some work for airflow.......but the 0.5 OCC head and 27 watts really does the business

[sydsut]

I'm sure I will kreed as I love my Subtank mini clone.

[Deleted]

yeah........but 7ml !!!!

Nice

[phatfil]

hi kreed any chance you detailing the mods to the rba base to increase the airflow?? tia

[Deleted]

I could if I'd done it

The way I understand it......you dremel out 2 bits of the metal in the base .......on each side........to turn the 4 holes into 2 slots

Then deepen the juice channels in the side

I think it was decoy that had done it

[phatfil]

Cheers, i had noticed that the draw using the rba head was more constricted, im currently using the 1.2 ohm head as i managed to dry burn the 0.5 ohm head, ive tried to recoil the burnt coil head but its not so easy.. getting the coil in is one thing, wicking is another..

[decoy]

May 27, 2015 14:42:29 GMT kreed said:

I could if I'd done it

The way I understand it......you dremel out 2 bits of the metal in the base .......on each side........to turn the 4 holes into 2 slots

Then deepen the juice channels in the side

I think it was decoy that had done it

yeppers slotting 2 air holes into one makes it more like the occ heads for draw
and enlarging the juice channels helps stop dry hits at higher watts with thicker juices(up to 50 watts with no dry hits /or using it at .3 ohms on mech and alls good)