Joytech mod with kanger toptank

[pipeman01]

I bought this combo in red from FT a few weeks ago.

Nothing wrong with the equipment per se, however the atty doesn't sit flush on the mod, so there's a small gap (maybe half a millimeter) which causes the atty to wobble.

I assume I can just put in a thin plastic or rubber washer to take up the slack so to speak? 

Annoying thing is the atty fits other mods fine and other atty's fit the joytech mod fine... but it's the only red mod / atty combo I have so want them to match

[dalealan]

Grab something like these www.fasttech.com/p/2173201

[pipeman01]

nice, but pricey for a washer

[dalealan]

But there's ten of em haha cut a disc out of an old credit card and drill a hole in the middle. It'll do the same thing

[anon4]

I've had tons of joyetech wismec eleaf etc they all have that shallow 510 pin. They loosen up over time. The important thing is not to force it or you can break it, I've never had a problem yet even with the tfv4 which is a known culprit for breaking these. I've recently acquired an istick 100w tc and to my amazement things sit flush right away. The smok tfv8 I am wary of though that has a big protruding pin

[norfolkphil]

Hey pipeman01

Get yourself some of these washers.
www.stealthvape.co.uk/rebuildable-supplies/clear-atty-gaskets

Also useful for stopping your mod from being scratched by your atomiser.

[pipeman01]

cheers Phil, £2 for 10 is a decent price.