Diy dna75 parallel build problem

[Grandad]

Just built myself a dna75 parallel mod, everything is working ok but the battery percentage is a little up and down. Its on 75% i take a toot and it will drop down a percentage or two and then go back up a percentage or two.

Do i need to change anything in escribe i took the chip from a single 18650 mod thought it would still be the same settings as only being in parallel.

I have been through all the connections and all seem good, im using a married set of vtc6 batteries

Thanks 

[VapingBad]

They should be the same settings, you could run battery analyser to get a curve for those batteries for the best accuracy, but the 75 is just a dumb battery meter that works off voltage not like the fuel gauge on DNA 200 & 250. In Device Monitor (have pack & level checked), have a vape and watch if it takes a long time for batteries to recover after a puff, here is an old 25R you can see that the battery takes a few mins to recover.  It went down to 71% nad right now the gauge is 81% after that puff, the time scale for DM was 60 seconds.

[Grandad]

Sorry problems with internet, just done it and it dropped from 75 to 73 then went to 74 and then 75 took about 30 seconds. Done a video but cant upload it so took a picture hopefully it helps. Thanks VapingBad

[VapingBad]

I don't think it is anything to worry about just the way the meter works and the time it takes batteries to settle.

[Grandad]

Thanks VapingBad have been using it since i got up this morning and it does seem to of settled down a bit will fully recharge the cells and see what happens, thanks again

[tim]

I have noticed a difference in readings between the 75 and the 200 Grandad and VapingBad. Not just battery levels, but temperature readings too. I see a rise (after initial pre-heat) up to "set" temp on the 200, but if I put the same atty on a 75, it hits the limit almost immediately. All being set the same (pre-heat, watts, temp limit etc.) I assume a firmware update will rectify this in the future...... hopefully.