Vandy Vape Berserker mini rta

[smokingaces]

Hi Everyone

So I purchased the Berserker mini MTL had it about a week now and have tried the coils it came with and now my own, am on fluff pop but finding the flavour very muted.Any ideas?

[mecnun]

Started using it last night with the coil that came with it and flavour is good so far, on par with my siren2 although I wish it had higher air flow setting than the max one. The problem has been incessant leaking from the airflow holes every time i have top filled it. This time I bottom filled it after googling the issue and no leaking so far touch wood. Not sure i want to do that all the time. Are you used to a slightly bigger airflow and that maybe causing your flavour issue?

[beedee]

I found flavour in the Siren 2 muted, then found I’d just put the coil too close to the deck, raised it a little and now it’s fine, maybe worth a try?

[smokingaces]

so changed it too a A1 Kanthal build coming out 1.04 ohm flavour is a little better, had no leakage issue with top fill. going too try a different juice in it, as some of the fluff pop I had has been hit & miss with the flavour.

[pancser]

Sorry I am a bit late to the party(as usual) smokingaces
I had issues with the flavour and leakage since I use my Berserker Mini but I found this on FT forum and it works.
If you remove these orings(pics below) can improve of the performance of the Mini





After refill you need to swipe away some juice from the side of the rta that is the only negative effect




I hope it helps
P

[mecnun]

thanks for sharing this. I am gona try it. What I have been doing so far is closing the airflow, top filling it and then screwing the top back on whilst holding the tank upside down. Open the airholes and blow into them. Then turn it back up and put on tank. Leaking has stopped mostly but still get some from the air holes now and then. The way this tank is designed when you screw it on it seems to create air pressure inside , you can hear it when you open it up from top.

[apostle51]

I found the flavour pretty pants when I used my own straight kanthal coils. I bought vandy vapes pre made Ni80 fused Clapton wire and made my coils from that.
It’s the same stuff that the premade coils that come with it are made with and the flavour is how it should be.

Surprising how coil material and design can have such an obvious effect on flavour