Recent Posts

Thanks all for the heads up, 10 ltrs from Darkstar a couple of pound more than 15 was a year ago, ATM.

Yeah, but to argue against my self mechs will work after the apocalypse (until the battery runs out), MacGyver, I can hot wire a car mod.

Do it Neil, this one packs down quite modest for winter, in the summer leave the frame out and just unhook the hammock and hang it in the sitootery. Also can move it in and out of sun or shade so easily. Treat yourself, you might even deserve it

andre likes their RY flavours and normally has one, amongst other flavours, on the go at the LSE vape meets.

DIY from Hangsen tobacco concentrate with 100% PG, mixing 4-5 litres 0 nic at a time with a few hundred ml at 50 mg, then mix those 2 once every month or two down to 5 mg/ml.

Sharing, thanks MrDJ

No they are not PCB protected, your protection is using a good quality high current (amps) rating battery and a decent device. Unless you had a dead short circuit in a mechanical mod you should never get into a position that overstresses these batteries. I doubt you can get protection circuits that would work at vaping wattages unless you vape quite low, but they add a few mm to the battery and wouldn't fit any of today's devices.

IMR is a battery chemistry that would guard against chargers not stopping charge properly amongst other things, but I don't think they are made any more as a small change in chemistry negates that and good chargers are cheap and readily available today.

AW (Andrew Wong) was a supplier/manufacture who reportedly bought only the highest grade batteries and relabelled them, that was great 8+ years ago but not needed now the cells recommended above are even better.