Please note, any banner ads that you see at the top & bottom of the forum are placed there, not by us, but by our host Proboards. Therefore neither the items advertised, or the vendors, are endorsed by this forum.
Post by KnightStalker on Jun 26, 2014 10:52:47 GMT
Well i figured i would update this post, i managed to fix the issue on one of them, my other was ok - the top piece that holds the 2 allen screws, does indeed unscrew from the base of the atomiser, which then gives you access to the lower insulator and much easier cleaning room as its just a big hole without the top piece separating the 2 wells, ill try and grab a pic next time i rebuild, but its just normal threaded so should come away easily.
Post by KnightStalker on Jun 18, 2014 21:36:41 GMT
Thanks ionian migrated recently - ill have a look through the countless packets of o-rings for various atties and see if one sits nicely.
As for the insulator, it looks like one big piece of delrin pushed in from the top, but ill be damned if i can push it back out from the 510 - not sure why infinite did this recess thing, cant get it to work on anything but a nemesis lol not even my ohm meter will pick it up.
Post by KnightStalker on Jun 18, 2014 20:19:35 GMT
Hi guys, long time vaper, new to these forums, usually im on the others most of the time, but im getting bored of the rules etc which prevent discussion on certain items, so im migrating to a better place
Post by KnightStalker on Jun 18, 2014 20:15:28 GMT
Ive also got one too, and yea the center post is silly recessed into the 510 connector, i cant work out why that is nor can i work out how to remove the insulators to reseat or modify them to push it out slightly - the other thing is the hole in the post will more than likely be obstructed by the knurled nuts if you take it out too far - Any other tips or tricks from owners?
Please note, any banner ads that you see at the top & bottom of the forum are placed there by our hosts, Proboards. Therefore the items advertised are not endorsed by the forum.
migrated recently - ill have a look through the countless packets of o-rings for various atties and see if one sits nicely.