phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 22:35:51 GMT
following in the theme of communicating with the g/f
"Time for a bonk"
"Off home u go"
and "have u done the washing up yet?"
could be possible screen candidates..
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 22:17:42 GMT
thanks kreed just what i need
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 22:09:23 GMT
you sure can Huff ethanol, and it goes a lot further than if drunk too.. but you do need close to azero pure stuff.. not too tricky to create wink wink.. i have vague recollection of huffing ribena flavoured ethanol in my early teens and the ensuing hangover too.. ( hey it was better than glue or butane the other popular 'huffs' at the time...) as long as its in a concentration below the flash level then its safe to vape explosion wise at least. its an inert solvent for active chemicals and flavours such as THC and other phytocannabinoids so can be used to transfer matter into a PG suspension via simple dilution and heating to evaporate off the ethanol.. but not much use for getting pissed while vaping tho as the concentrations in juice and the 'portions' vaped are miniscule.
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 21:43:16 GMT
thanks again VB I just need a simple "put me down Liz" screen for when the g/f starts playing with my toys
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
SOLD
Oct 14, 2015 21:37:02 GMT
Post by phatfil on Oct 14, 2015 21:37:02 GMT
apparently they all have the option?? perhaps you need to state that when ordering tho?? the 8th section of the above pic talks about the BF option and shows pics of the round and hex rda models..??
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 21:28:16 GMT
Is there a specific editing tool for these or is it a simple case of using paint/gimp and limiting the pic to a 128 x 32 bitmap before saving as a png image...
thanks in advance
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 21:24:34 GMT
Cheers VapingBad think i have some ex multimeter leads with plug terminals i can re-use, my 'Useful bits' boxes take up a lot of loft, garage and shed space so im sure i will have something i can solder up when needed.. and its only going to be an issue when the 2nd battery arrives..
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 21:15:51 GMT
Think i will give the analysis a miss till im better versed in these things - am building up a backlog of homework all the film resistors i have are 1/4-1/2w so no good for the job.. - i will read up.... Ive lifted the suggested values for the battery in the vt200 and am using those now, so far its still on its from the shop charge.. saying that i bet the next puff will give me a low battery warning..
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
SOLD
Oct 14, 2015 21:08:46 GMT
Post by phatfil on Oct 14, 2015 21:08:46 GMT
Thanks for checking, i do keep revisiting their site to drool over the bf attys GLWS
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 21:07:28 GMT
ok slowly i think im beginning to digest this new info.. thanks for your patience guys.. so the 4 pin JSX socket IS used by a 3rd party charger but not for charging but for providing real time feedback on the 3 cell battery status during a charge. if you haddnt guessed ive not used lipo batteries for anything in the past... If relying on the single battery i would rely totally on usb charging, I have however ordered a 2nd battery, so i wont be relying on usb charging and will hopefully be swapping out dead /low batteries with fully charged ones so will need an external charger it seems.. thanks again for bearing with me while the penny slowly dropped.. Cheers VapingBad decoy your both superstars!!
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 20:13:36 GMT
ok im a lil confused VapingBad the supplied lipo charger has only 1 connector which is the 4 pin white socket which accepts the 4pin plug from the battery module ???? i would take a snap or 2 but i cant find me camera right now.. So?? if using a 3rd party lipo charger it wont have the 4 pin socket into which i plug the battery instead i will charge via the current out terminals with some diy plugs?? a pic i lifted of GB
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
SOLD
Oct 14, 2015 20:05:44 GMT
Post by phatfil on Oct 14, 2015 20:05:44 GMT
does it have the bottom feed option????
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 19:18:03 GMT
cheers.. thought something was up with KOV.. not ordered from em for a while but when i looked at their TFV4 mini presale the £4 pnp made me step back and leave the site PDQ
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 19:03:05 GMT
the charger i have, bought after recommendations in here is a nitecore D2, it has 240v ac input and 12v dc input.. you can charge the evic mini via usb with a 5v dc supply too. ebay link Just an example not a recommended seller/deal.. you may want to revisit the gearbest order and cancel the mod and order it separately as the battery shipping options are more limited and can take upto 6-8 weeks to arrive my batteries from fasttech took closer to 4 weeks to arrive, while non battery deliveries with no special options that cost extra will arrive within 2 weeks as a rule.. if batteries are in an order with more goods they will all be sent out together along the slowest route.. (you learn these tricks after being caught out... ) gearbest have a uk warehouse it only stocks a limited subset of goods, check on the ad page for the eu warehouse option, if its not on the ad page its not there, [a href="http://www.gearbest.com/warehouse/?wid[]=3"]gearbest eu/uk stocks (short delivery)[/a]
|
|
phatfil
Super Member
Joined:April 2015
Posts: 2,863
Location:
Likes: 1,935
Recent Posts
Last Online Aug 14, 2020 13:58:49 GMT
|
Post by phatfil on Oct 14, 2015 18:03:58 GMT
Did you run the test to get the exact numbers of the battery? Do that, and set it up by the numbers that will come up from escribe. To me, it did a significant improvement of the battery life Test? do you mean the battery analyser ?? if so can you please describe whats needed step by step to perform this test? afaik you need a fully charged battery and a throwaway coil fitted in an atty attached to the device, and set a discharge wattage 40w reccomended??? is that it? how long will it take ? and is it safe to leave unattended?? many thanks in advance..
|
|