Vision Nano Clearomiser problem

[Davy Tee]

Just got some Vision Nano Clearomiser,s, the first one i tried worked no bother second one seemed to leak from the bottom into the battery, is this a problem others have found with this clearo, does it mean i have to chuck that particualr one.

Im using it witha Riva 1100

[raid2506]

I'm not sure how it could leak through the centre and out the bottom unless it's been built wrong.

Will have to wait for a grown up to come along with the right answer.

[Davy Tee]

unless ive spilled some down the outside of the vessel maybees ?

[OneDay]

The thing with these type of rebuildables is that there's only 3 ways juice can get into the centre tube (other than obviously by accidentally dripping juice down there as you fill).
The first is at the point where the atty head screws onto the centre tube. Check the O ring and make sure it's screwed on tight. The top cap can sometimes catch on the atty head and unscrew the atty a bit as you remove the head, so check that the head is tight each time you take the top cap off.
The second is at the point where the top cap presses down on the atty head to make a seal, check that the top cap is screwed on tight.
The third is at the point where the wicks exit the centre tube. Check that the little silicone 'top hat' is seated firmly on top of the head to minimise this gap

I hope this helps

[lobeydosser]

The Nano Clearomiser is not a rebuildable.

It is a Bottom Coil clearomiser and the only way e-juice will come out the bottom is if it goes down the central tube as you are filling it.

The mouthpiece screws onto the central tube and the outside rim of the mouthpiece then seals onto the plastic tube with an O ring.

I have 4 of these excellent clearos but I have found them a bit tricky to fill. I have found that the easiest way is to slowly trickle the juice down the outside on the central metal tube and stop about an 1/8th of an inch below the top of the plastic outer tube.

If you are getting juice at the bottom it may be cracked. Empty it out and fill it with water and leave it standing some where. If it is leaking then send it back to the Vendor.

[Davy Tee]

aye, will do that cheers

[Davy Tee]

Do the Nano,s need to be cleaned out like other clearos or with them not having wicks is it ok to keep filling ?

[raid2506]

Feb 12, 2013 0:59:33 GMT lobeydosser said:

The Nano Clearomiser is not a rebuildable.

It is a Bottom Coil clearomiser and the only way e-juice will come out the bottom is if it goes down the central tube as you are filling it.

The mouthpiece screws onto the central tube and the outside rim of the mouthpiece then seals onto the plastic tube with an O ring.

I have 4 of these excellent clearos but I have found them a bit tricky to fill. I have found that the easiest way is to slowly trickle the juice down the outside on the central metal tube and stop about an 1/8th of an inch below the top of the plastic outer tube.

If you are getting juice at the bottom it may be cracked. Empty it out and fill it with water and leave it standing some where. If it is leaking then send it back to the Vendor.

That's what I thought ???

[lobeydosser]

Feb 12, 2013 9:30:01 GMT Davy Tee said:

Do the Nano,s need to be cleaned out like other clearos or with them not having wicks is it ok to keep filling ?

I use my Nanos to test e-juices that I mix and so I am constantly cleaning them out and refilling with other flavours.

To do so I use a syringe. I half fill them with water with the syringe, put the top back on and then give them a good shake. Top off and empty out. I do this a couple of times.
I keep an old mug half full of water, on my desk with a syringe there just for cleanouts.

Just make sure that you don't accidently drink the contents of that mug or you will be in Cloud Coockoo Land for a month!!!!

[Davy Tee]

im not having much luck with the Nano clearo just filled one and its gurggling and popping and making a hell of a noise in general, im sure i didnt get any juice down the hole, what ami doing wrong, its putting me off vaping

Also i got a electric metallic tatse from it like when you used to touch your tounge on a battery, weird man ???

[kibbster]

Popping from a clearo is fairly normal when it's working.
Gurgling is liquid in the airtube generally, blow through it rather than sucking (over a tissue) that should clear the worst of the liquid out.
Sometimes Clearos just do that and it's annoying as hell.

[Davy Tee]

i was so careful not to get any down the air tube but i must of, back to the drawing board me thinks.

[lobeydosser]

I don't understand how you can get any liquid down the air hole as the central tube sits about 3/8ths of an inch above the rim of the outer tube.

All I can think is that it is either condensation inside the central tube or it is a fault in manufacture.

Empty the Nano, blow through it as suggested by Kibbster and then stand it on a radiator to dry out the central tube. Then refill it and vape and if it still gurgles then it has a fault.

[Davy Tee]

aye will do cheers

[Davy Tee]

still doing it so just binned them. Im on the look out for a good Clearo now i can trust.