holycow
Full Member
Joined:April 2011
Posts: 126
Location:
Recent Posts
Last Online Aug 4, 2011 22:25:24 GMT
|
Post by holycow on May 28, 2011 13:53:24 GMT
A. You get stupid questions like this one! :-[ Right!! I have at least managed how to put the battery in! SO there ishope for me! BUT! I just cannot for the life of me fit an atomizer to it ??? So can someone REALLY spell it out for me please Her goes - there are two littleattachments - am I right inthinking that I do not need those? So looking at the part where the atomiser goes on the outer casing there is a screw on silvery coloured threaded nut after that at end is the brass polished end piece - Do I leave both of these on? And then do I just try andscrew theatomizer into the connection inside those two pieces? I have got riva atomizers, clearomisers tank atomizers anddualcore ones are ANY of these compatable? Thanks for your replies! (I am going to hide now)
|
|
hifistud
Super Member
Im A Fluffy Bunny Too
Watching, waiting...
Joined:March 2011
Posts: 1,035
Location:
Likes: 26
Recent Posts
Last Online Jun 18, 2013 20:10:50 GMT
|
Post by hifistud on May 28, 2011 15:59:24 GMT
if it has a 510 thread, it'll work on a TS - however, the top cap on thee Collection tank (the brass bit) may not accommodate a Clearo without some effort. You can always leave the Collector Tank off if you want to use a clearo, if you don't want to hassle on with it... have a watch of www.vapourtrails.tv/?p=521 where it's all discussed at length...
|
|
|
Post by Perpetua on May 30, 2011 8:53:25 GMT
Have you got your GGTS sorted out now HC?
|
|
camperman
VENDOR
Joined:February 2011
Posts: 1,114
Location:
Likes: 5
Recent Posts
Last Online Mar 1, 2022 16:49:35 GMT
|
Post by camperman on May 30, 2011 10:01:36 GMT
holy if you take the battery out and fit the atomizer first its the easiest way as if you tighten the tube up to much its hard to fit an atomizer. if your wanting to fit a clearo to the GGSS remove the top brass cap and look inside were the connector is and push the centre pin down (without the battery inserted) and screw the atomizer on then replace the brass cap over the clearomizer/atomizer and then insert your battery and tighten the tube, hope this helps
|
|
|
Post by Perpetua on May 30, 2011 13:24:12 GMT
I find it easier to pull the centre post/plunger out a wee bit HC.
( Not all the way out, otherwise you're likely to lose the weeny o rings. )
Screw your atomiser in . . . then push the centre post back up until you feel some resistance where it has made contact with the atomiser end.
Then fit batteries . . . if you are completely stymied, you're very welcome to send it to me, I'll get it set up and posted back to you.
|
|
holycow
Full Member
Joined:April 2011
Posts: 126
Location:
Recent Posts
Last Online Aug 4, 2011 22:25:24 GMT
|
Post by holycow on May 30, 2011 16:34:27 GMT
Have you got your GGTS sorted out now HC? Hi Perpetua Nope, I haven't - and a friend who is also a vaper came today - she is more patient thenI and reads instructions - she couldnot connect ANY of my atties either - shewas going to look it up on youtube whenshe got home.
|
|
|
Post by Perpetua on May 30, 2011 18:45:19 GMT
It is a learning curve with a GGTS HC, I had a very fraught time with my first one when I got it . . . if between you, you are unable to crack it, then my offer is of course still there.
As well as Hifi's excellent reviews there's this one from Scott which might help explain things a bit better than the written word . . .
|
|
holycow
Full Member
Joined:April 2011
Posts: 126
Location:
Recent Posts
Last Online Aug 4, 2011 22:25:24 GMT
|
Post by holycow on May 30, 2011 18:54:57 GMT
It is a learning curve with a GGTS HC, I had a very fraught time with my first one when I got it . . . if between you, you are unable to crack it, then my offer is of course still there. As well as Hifi's excellent reviews there's this one from Scott which might help explain things a bit better than the written word . . . I must have missed your offer Perpetua - would you care to refresh me please?
|
|
holycow
Full Member
Joined:April 2011
Posts: 126
Location:
Recent Posts
Last Online Aug 4, 2011 22:25:24 GMT
|
Post by holycow on May 30, 2011 18:57:03 GMT
Just found your offer! yep!!! I think I would like to send it to you if you do not mind - thank you! That is of course if camperman cannot direct me to an atty onhis site that fits without fiddling!
|
|
|
Post by Perpetua on May 30, 2011 18:59:13 GMT
Send it to me, I'll set it up for you and post it back again . . . once you've seen it working, it will give you the confidence to do it yourself. I'm 100% reliable, I hope you have no fears on that count - it's a 2 minute job for me to do.
|
|
|
Post by Perpetua on May 30, 2011 19:00:46 GMT
I'll PM you my address, I've plenty of LR510 atomisers to set it up with, which I suggest you start off with, to get the feel of the device.
|
|
holycow
Full Member
Joined:April 2011
Posts: 126
Location:
Recent Posts
Last Online Aug 4, 2011 22:25:24 GMT
|
Post by holycow on May 30, 2011 19:05:15 GMT
Thank you! I have NO doubt that you are nothing but honest!BUT! what I cannot understand is that I have theLR510 atties!!!Do I need to send those two little nuts that came with it?
|
|
deesigner
Super Member
Joined:June 2010
Posts: 2,539
Location:
Likes: 884
Recent Posts
Last Online Apr 7, 2015 14:29:33 GMT
|
Post by deesigner on May 30, 2011 19:14:54 GMT
Is it a 510 or a 901 thread? The other bits may be adaptors?
|
|
camperman
VENDOR
Joined:February 2011
Posts: 1,114
Location:
Likes: 5
Recent Posts
Last Online Mar 1, 2022 16:49:35 GMT
|
Post by camperman on May 30, 2011 19:17:50 GMT
Just found your offer! yep!!! I think I would like to send it to you if you do not mind - thank you! That is of course if camperman cannot direct me to an atty onhis site that fits without fiddling! the atties from the BW you have will fit and clearos fit holy. youll kick yourself when you see how they go in but to be fair when i first opened the parcel i though WTF how do i do this so its not obvious if your not technically minded that way. i could do a video to send to you if you didnt want to go through the rigmarawl of posting it ? sorry to step on your toes here perpy for saying that by the way.
|
|
|
Post by Perpetua on May 30, 2011 19:25:08 GMT
The two little things are re-threaders HC . . . if you wanted to use a 901 atomiser with the GGTS . . . I'll lay pound to a penny it's getting the centre post making a good connection that you're maybe confused about.
PS. Send a battery though, as I can then post it back fully operational with the locking nut locked, so there'll be no fear of it activating.
|
|