Another question from a numpty!

[holycow]

I have fixed the arry to a screwdriver and all I am getting is a gurling noise andmouth fulls of liquid! so what did I do wrong this time?

[Perpetua]

I don't know, it's fine on mine . . . just tried it HC.

Are your batteries well charged?

Have you over filled your tank?

[shamreez]

Check out this video..

The best video I have seen for the arry tank you might get it right.
I dont own one yet so cannot comment from personal experience

[holycow]

Just poured half the liquid down the sink (I had filled it to the rim) it WAS working fine!! BUTnow I am getting mouthfuls again!! yuk!

[Jezarel]

If its been inverted too long then juice collects around the coil. Take the drip tip off and LIGHTLY absorb some of the juice from the coil. A little sausage made of tissue or a cotton bud. Do it real lightly, capillary action will do the work for you it just needs a little contact.

Regards
Jez

[ian]

As already said if you overfill the tank then juice will leak from the connector.If this happens then you need to wipe away the excess juice from the connector on the device otherwise it wont vape properly and will gurgle.Arry is now doing a clearomiser tank upgrade kit,its some better o-rings to add to the clearomiser which will stop any leaks.Ive just received mine today and the o-rings are very good.I got five in the pack and they are reusable.Might be worth speaking to Arry if you are getting alot of leakage,he will help you out.

[Jezarel]

When refilling mine last night I have found that the way you put it together makes a huge difference. The rubber bung that sits over the coil must be on (with the wicks running through the indentations) but it must be on the clearo BEFORE you put the lid on. This makes the seal. I noticed that when mine leaked all over the vaping box the bung had moved a little when I put the lid on. If the seal is tight and straight it should lay on its side with minimum leakage.

Jez

[shamreez]

Jun 15, 2011 10:47:18 GMT Jezarel said:

When refilling mine last night I have found that the way you put it together makes a huge difference. The rubber bung that sits over the coil must be on (with the wicks running through the indentations) but it must be on the clearo BEFORE you put the lid on. This makes the seal. I noticed that when mine leaked all over the vaping box the bung had moved a little when I put the lid on. If the seal is tight and straight it should lay on its side with minimum leakage.

Jez

Yeah thats why I posted that video where he clearly mentions the same

[birdy]

I will not be bothering - far too bulky and why would you need such quantity on board, 2 days worth talk about overkill .Think i will stick to my riva and top up cartridges when required with my flavour of choice at the time .