Please note, any banner ads that you see at the top & bottom of the forum are placed there, not by us, but by our host Proboards. Therefore neither the items advertised, or the vendors, are endorsed by this forum.
We are a new company that is bringing a few high end mods and atty's to the UK and Europe.
The first mod is the Pisces-T, a telescopic mod from the Philippines, produced by J2p mods for SHMOvapes to sell exclusively in the UK and Europe. This version is different to the US/Malaysia version and will only be available in very limited quantities and only from us.
The Pisces-T will be in the UK in approx. 1 week so will be for sale hopefully by latest of Friday. We will be allowing you to select the serial number you would like (if still available) at the time of purchase. The pisces-t is estimating to cost between £130 GBP to £135.00 GBP.
We will also be donating one Pisces-t to the Vapefest Raffle!
The pictures below are of the UK/EU version of the pisces-t.
Please contact us via the forum, email or PM if you have any questions.
Pisces-T by J2p Mods -------------------------------------------------------------------------------- Full Specs: - Full mechanical - Made up of 304 Stainless Steel - Adjustable COPPER pins - Telescopic (18490 - 18500 - 18650) - 5 parts - Engraved logo - Serialized - Full 304 SS including locking ring - Light weight - Soft Button - With locking mechanism
Sizes: - Outside diameter of the mod = 21.7mm - Height (using AW 18650 battery) = 83.43mm - Height (using AW 18490 battery) = 68.5mm
Just under 22mm by a margin, the nemesis is 21,82 mm in comparison.
I have to admit, it is tiny but kicks a punch at the same time... The throw on the button is about 1mm (if that) and you can get a Kayfun 3.1 on the top and the button does not fire when you stand it on its end.
Well we decided last night to do a random check of the mods while we were sorting out the serial numbers for quality control reasons. We noticed that there was a manufacturing defect on the inner tubes of the few we opened. A small but noticeable issue with the finish on the inside of the tubes. So we opened quite a few more and we realised very quickly that this was not an isolated problem. I immediately contacted J2P Mods and we both agreed not to start selling them until the issue had been rectified. So ALL of the mods are being shipped back to the Philippines on Monday to be checked and have new inner tubes made. It seems all the inner tubes were not checked correctly by his quality control guy. New checks are being put in place right now to make sure this does not happen again.
Needless to say both SHMOVapes and J2P Mods are not happy about this situation in the slightest but we both agree that we will not contemplate selling anything with defects.
We will update you as and when we find out but we expect there to be around a 2-3 week turn around
The mods have finally landed. Well we have had them for a little while but we wanted to give them a good check first.
Sorry for the delay but we would not sell anything unless it met or exceeded our expectations. The issue might have been a small one but I hope you can appreciate that we & J2P were not willing to lower our