AGA T

[yesitsme]

I have an AGA T and I have not wicked it yet but played around with it for a bit (still waiting for a burner). The problem I have is that in order to get the tank tight I have to tighten the nut to point where is is disappearing into the plastic grommet thing on the top. Also there are two screws that just seem to be there to fill holes, they do not hold anything together.

Is there a better rebuildable atty?

I have an I30 that vapes like a dream but I want to improve my skills.

[maccafan]

The tank on the Aga-T is tightened by screwing the connector end and the top deck onto the center post compressing the O rings onto the edges of the tank..

That little nut is just a stop nut to prevent the center post from sliding up or down too much..It does not need to be tight.

The RSST is recommended by many as a starter Genesis atty.

[Ron]

The two screws in the deck are one for filling and one for holding the neg wire when you coil

[giles]

I love my aga-t. I recommend this build, although it isn't the simplest. You might like to start with something simpler like this.

If you want something easier to practice building, I recommend an Igo-L. Evods and protanks are also pretty easy. But I don't think the aga-t is hard. Certainly a lot easier then my Nautilus (oddy/penny type).

[yesitsme]

Many thanks Ron and giles.