kingofswords
Super Member
Joined:October 2011
Posts: 1,107
Location:
Likes: 88
Recent Posts
Last Online Dec 27, 2023 13:45:35 GMT
|
Post by kingofswords on Nov 17, 2011 22:35:38 GMT
sorry spamming the board at mo as i had few questions but been too lazy to put into words just seen new syringes at health cabin and was gonna put in order next week(for other stuff)...i was going to dilute some strong juice i got into 20ml bottle(only spare i got) so just wondered what size syringe i should get for flavour/juice and VG? would 2.5ml be best and do i have to rinse the syringe out each time i change what im using ot for?
|
|
Gordy
Super Member
Joined:September 2011
Posts: 11,515
Location:
Likes: 100
Recent Posts
Last Online Feb 15, 2013 0:28:19 GMT
|
Post by Gordy on Nov 17, 2011 22:37:51 GMT
im guessing the smaller syringe the better accuracy but could be a pain to move large quantities... at HC prices you may as well get a few of them so you dont need to share between liquids
|
|
|
Post by Perpetua on Nov 17, 2011 22:41:56 GMT
I'd get a couple of 2.5ml & a 5ml King. They should cover all your needs . . . I just rinse mine out in some warm water after I've used them, otherwise you could end up with a sticky, festering mess.
|
|
kingofswords
Super Member
Joined:October 2011
Posts: 1,107
Location:
Likes: 88
Recent Posts
Last Online Dec 27, 2023 13:45:35 GMT
|
Post by kingofswords on Nov 17, 2011 22:47:11 GMT
yeh only 20p...1ml seem a bit of pain in the **** though
to mix it do i just shake the bottle?
|
|
|
Post by Perpetua on Nov 17, 2011 22:58:19 GMT
My tried and tested 3 step guide to mixing King . . . Slosh Shake Steep Simples!!
|
|
blakey
Super Member
Ninja Maestro
Joined:June 2011
Posts: 9,206
Location:
Likes: 4,242
Recent Posts
Last Online Nov 22, 2024 19:52:52 GMT
|
Post by blakey on Nov 17, 2011 23:03:00 GMT
My tried and tested 3 step guide to mixing King . . . Slosh Shake Steep Simples!! I do that every morning in the bathroom Just rinse the syringe out with warm water when you are changing the flavour of the juice or if the syringe is going to be unused for a while, and to clean the needle you just need to draw some clean water through it using the syringe
|
|
DiscoDes
Super Member
Perp's Personal Aide
Joined:April 2011
Posts: 11,588
Location:
Likes: 6,099
Recent Posts
Last Online Oct 24, 2022 6:13:15 GMT
|
Post by DiscoDes on Nov 18, 2011 7:59:38 GMT
Kingofswords: I have a pack of 10 syringes here that I bought off of Ebay you're welcome to a couple if you want, they are the 3ml size ones. Send me a PM with your address and i'll send you a couple in the post. EDIT - no needles, just the syringe
|
|
cigeliquid
VENDOR
UK e-liquid vender
Joined:June 2011
Posts: 314
Location:
Likes: 213
Recent Posts
Last Online Dec 2, 2020 19:11:41 GMT
|
Post by cigeliquid on Nov 18, 2011 16:11:49 GMT
Dont forget for VG you need a big bore needle try to get a 14g this is the best size for VG smaller than this means it takes longer to suck the thicker liquid up,any size syringe is fine I tend to just use 3ml pipettes for my own DIY mixing very simple fast and easy to clean out in a glass of water as i go. My very very quick mix (this is just how i do it not a guide) 1 Pipette into PG base liquid with Nicotine suck up 3ml then squirt it into a small empty dropper bottle, replace top on PG nicotine base bottle. 2 rinse pipette in cup of water-- two or three pumps and its clean 3 Pipette into PG With NO nicotine suck up 2 ml of PG squirt that also into the same dropper bottle then replace top on PG bottle 4 Rinse again in cup of water 5 Pipette into VG With NO nicotine suck up 2 ml of VG that also goes into the small dropper bottle replace top on VG bottle 6 rinse again in the cup of water 7 Then i Add 3 or 4 drops of tobacco flavour( flavorart) 8 Replace dropper on bottle and in my case screw on spiky thing cap shake bottle i dont steep when i use tobacco flavour so thats me done 7ml of around 22mg made in 30 seconds (was using 52mg base) next refill my clearomizer thing 1 Take fork out the drawer slide the prong down the hole in middle taking care not go in to far damaging the coil then prize out the top of clearmizer and slide it down the prong so it grips the prong. 2 pop the lower seal out same way and also slide it down a prong till it grips. 3 with both seal and mouthpiece still on the fork rinse them in the glass of water or under the tap 4 take spiky thing and slide tip down one fill hole and top up the clearomizer you can use one of the spare tips in the other fill hole as a vent and to show when full, the spiky can suck back any excess liquid 5 Replace both the seals and thats me done refilled in 20 seconds from start to finish
|
|
kingofswords
Super Member
Joined:October 2011
Posts: 1,107
Location:
Likes: 88
Recent Posts
Last Online Dec 27, 2023 13:45:35 GMT
|
Post by kingofswords on Nov 18, 2011 16:42:06 GMT
thanks des=)
pm sent
|
|
DiscoDes
Super Member
Perp's Personal Aide
Joined:April 2011
Posts: 11,588
Location:
Likes: 6,099
Recent Posts
Last Online Oct 24, 2022 6:13:15 GMT
|
Post by DiscoDes on Nov 18, 2011 16:48:56 GMT
replied
|
|