from the Squape +R site
Flooding problems.................Set cotton or silica lower into the liquid channels. Cotton and silica should sit fluffy in
the channels. Use more cotton.
Dry hits .....................Try less cotton – do not press the cotton into the liquid channels. Cotton should sit fluffy in
the channels. Make the silica cords a little bit fluffier and if needed, shorten the cords a little.
I can’t remove the deck. ....................You’ve got several possibilities – In principle: The deck can be removed:
- About 30 min. in freezer
- Rubber, cloth or other expedients, which serves to protect the deck, attach to the deck.
- Pull with the pliers gently on the deck (even and to luff slightly) – do not pull the deck by
using the pliers without any protection on it. - Or use a rubber grip of a plierst to hold the
deck –
No contact to the mod / battery carrier ....................Adjust the centerpin
Jumping ohm ........................................................Cleaning of ceterpin and centerpin slot – preferably with toothpaste and interdental brush. Then put it in an ultrasonic bath.
I’ve got difficulties to fill the SQuape R with VG liquids. ........................Keep the tank at an angle and let the liquid
flow through the wall of the tank.
Where do I get a SQuape R? Shops:
www.squape.ch/shops.php My SQuape R is bubbling, but no flooding from the air hole..........Clean the drip tip intake and remove the
condensation.
Discoloration on centerpin .........................This is congealed condensate, which is partly rust brown discolored. cleaning with toothbrush and toothpaste.
My glass is cracked Replacement glass is available at our
partners and replacement instructions can be
found on
www.squape.ch/squape-r.php(currently in German only)
