Kayfun Lite Top Filling

[igual]

Dec 17, 2014 12:31:56 GMT stamina said:

Never had a problem top filling my russian/ kayfun clone.

The method I use is

1 Take top off
2 Put finger over air hole and fill it to just under top level glass line.
3 Put top back on and get it to bite/contact and turn but don't fully tighten it.
4 Turn atty upside down and remove finger over air hole
5 Tighten the top cap fully.
6 Good to go but first couple of vapes take small drags and if you need to make sure the air hole is clear, blow into air hole and watch the air come out of drip tip. Its not really necessary to do that but what the eck its fun.

Exactly the same on both my kfl v2 only difference is don't bother putting finger over airhole, and like others just get threads to but tune Atty upside down but I wait fir all the juice to drop into top area of atty then tighten.
You might get the tinyest amount of juice cone out the seam as you tighten it up, quick wipe with tissue and good to go?
Never had a leak from airhole or juice in drip tip doing it this way.
I tend to fill the kayfun up just past the mid section about 4mm shy of the chimney top.
Have used this with several different wick types as well no issues.

[Roger]

Dec 17, 2014 21:34:39 GMT lisburnvapes said:

Yea I do have a top cap that you can fill through , it's yours if you want it Roger

That is fantastic, I'd like to try that, thanks very much lisburnvapes  I'll PM you my address, also what do you want for it? very happy to pay and for postage etc.  

Also thanks to everyone who answered with your methods, much appreciated.  

[lisburnvapes]

FOC @ rogerh, I don't use it anyway