Mephisto v2 set up help

[c1booth]

I've finally had my clone delivered from fasttech so I've got everything to get going now but after watching YouTube videos on set ups it seems I havent
ive bought .3 & .25 kanthal and have a iStick and a v2 vamo on the way but it seems my wire is to thin and if I dual coil it's going to be below 1 ohms and not register on either of my devices. Is this correct?
has anybody any advice please

[Greg]

Try 10 wraps of 0.25 on a 2mm former. Should be around 1.3 ohm dual coils.

If you want a bit higher increase by a wrap or two or use a bigger former.

[c1booth]

So will that size wire be ok all videos were saying only use .4 up as the posts are so big
Was that coil you suggested single or double

[Greg]

Dual. Can't comment on your arty as I don't have one but if you use thicker wire you'll struggle to get above an ohm especially dual.

[*-SARIN-*]

To get it working you could just use a single coil to keep the ohms up, not ideal and the dripper will be at it's best sub ohm but at least you will be able to try it out?

[Greg]

If you do sub ohm make sure your battery is up for the job. If that statement makes no sense then don't sub ohm until it does

[c1booth]

I've only got a istick and a vamo v2 on the way
Would I need a mech for sub ohm then
Heard nemesis a lot and there always on the classifieds but know nothing about them

[Deleted]

on my mephisto i have 7 wraps each side of .25 wire sits at 1ohm have it around 19watts
gives 4.4volts on the ipv2 nice sweet spot for me .. waiting on my eleaf to arrive to try same
setup on that

[c1booth]

Jan 17, 2015 13:54:18 GMT @zuza said:

on my mephisto i have 7 wraps each side of .25 wire sits at 1ohm have it around 19watts
gives 4.4volts on the ipv2 nice sweet spot for me .. waiting on my eleaf to arrive to try same
setup on that

I've read the istick won't do coils at 1 ohm or below