Help pllllleeease ?!

[law]

 So my sub tank mini v2 is being a pain and slightly gurgling and what not . Cleaned it up , now I have an extra o ring that I can't find .mi think I've narrowed it down thoug , can you guys post a pic of the base of your sub tank , without the coil in ? So I can see where the coil,screws in ? 

[Perpetua]

Are these the sort of pictures you want law?











Or anything on the Tutorials?

allaboute-cigarettes.proboards.com/thread/50953/kanger-subtank-occ-rebuild-guide?page=1&scrollTo=886449

allaboute-cigarettes.proboards.com/thread/50745/kanger-subtank-mini-build-guide?page=1&scrollTo=883235

[phatfil]

if using occ stock coils priming the cotton with a few(5-6) drops of juice before use should sort it, if its an rba setup, ensuring the wick covers the whole of both holes in the cylinder and priming should also sort it..

you shouldnt need to use much force screwing in either type of coil head, just screw in till it stops, if u push in the bottom +ve contact pin in the base first, and hold a finger over it as u screw in a coil you should feel it engage and start to push a little on the pin so it stands a lil proud at the bottom of the 510 connector when screwed home.

if using clone occ heads that may be the problem???


also a lil gurgle when first primed/filled may occur just blow that all out into a tissue cupped around the base, and then it should be fine..  


good luck.. 

[blakey]

On the stock coils + the rba section there is an o-ring the seals the coil unit to the base, its a white/clear colour.
There is also an o-ring at the bottom of the 510 of the coil housing which denotes coil type
Lastly there are 3 o-rings in the tank section, top an bottom + one to seal the chimney

[law]

Is there one where you screw the coil in? I have one under the threads on the coil , I mean one on the base that you push the coil pin into ?

[dagl]

What size is the one you have leftover?

[Greg]

Jul 31, 2015 20:33:31 GMT law said:

Is there one where you screw the coil in? I have one under the threads on the coil , I mean one on the base that you push the coil pin into ?

No not really unless it's come off the bottom of the coil head.

[Perpetua]

Jul 31, 2015 20:33:31 GMT law said:

Is there one where you screw the coil in? I have one under the threads on the coil , I mean one on the base that you push the coil pin into ?

Is this picture any help law?

[Greg]

Jul 31, 2015 20:33:31 GMT law said:

Is there one where you screw the coil in? I have one under the threads on the coil , I mean one on the base that you push the coil pin into ?

Are you referring to this clear oring on the base of the coil head, there shouldn't be a clear oring in the base where you screw the coil head in, if there is put it back on the base of the coil head before screwing it into the base.

[law]

I'm looking for an above pic of the base if that makes sense ? I have a o ring around the bottom of the coil