West midlands - not so new to e cigs though!

[naDiel]

Hi everyone!

Started my journey with e cigs a while ago with the old cigarette look a likes that were absolutely wrong!

Then moved to the more advanced eGo type, through vision spinner 2 to my current setup that I will shortly be willing to change. 

So at the moment I rock a dovpo e-mech with fogger v5 tank. 

The only thing that I would like to change is the e-mech as it doesn't allow me to get as low in the ohms as I would like 

And maybe get some sort of RDA for a bit more of could chasing every then and again

[Get Off My Cloud]

naDiel , everyone should own a dripper or 20

[charliehorse]

Hello naDiel and welcome to the forum

[chykensa]

naDiel - hi and a warm welcome to the forum!
Have a look through the thousands of pages at www.fasttech.com - for less than a tenner and a couple of weeks waiting you could have a good quality clone dripper to play with, that would enable you to try out dual coils; this would give more flavour and vapour without needing to lower the resistance through the floor.

[Deleted]

Hi and from another west midlander.

[cHooBeyDoo]

Hiya naDiel and to AAEC
If you don't want to go the China route here are a few good and cheap UK sites:
www.kingzofvapour.com
www.noblevaping.co.uk
www.boldvape.co.uk
vapor-mod
www.sr-vapes.co.uk
www.myepack.co.uk

[gill2009]

A very BIG welcome to AAEC naDiel - enjoy 

[Perpetua]

Welcome to you naDiel.


I'm pretty positive you'll get some sound advice on what equipment to spend your money on!

[Roscopecotrain]

Hello and welcome to aaec.

[DiscoDes]

I'm enjoying this www.fasttech.com/p/1718100 with a Nickel coil, may not be airy enough for some but for me it's ok.

And it's cheap

[tim]

Hi naDiel to AAEC. Ask any questions about drippers you want, somebody here will have tried it and will give you advice. Just waiting for a Velocity atm

[Chrissie]

Hello & welcome naDiel

[naDiel]

Thank you everyone for the warm welcome!

Dual coil are already on the cards with the fogger however I bought 0.5 kanthal to play with and the e-mech doesn't really let me go below 0.5ohm... Which is a pain as I managed to build myself a 0.25ohm dual coil setup and wanted to see how it suits me.

Thank you for all the links to the online shops - already know FF by heart

DiscoDes - once I get my hands on a temp controlled chip I am sure I start doing nickel builds but till then kanthal it is

Tim - I have seen velocity's review by Riptrippers and was mighty impressed by it to such an extend that I think I might need one

[Deleted]

Welome to the forum naDiel
Nick