Boge Cartomisers

[amd]

Hi, can anyone tell me if you can get 3 ohm(standard) Boge 35mm cartomizers pre-punched in the UK. I have Googled various searches but cannot find them, only in lower resistances.

Iam looking for these to go in a small tank ( which I have to get as well) to go on my mini Provari

Any guidance appreciated.

Andy

[Perpetua]

Boges as a rule don't come pre-punched Andy, it's the Dual Coils that do.

But, you can either buy a punching device to do it yourself, or ask Jason at Vape Escape, he did I believe offer to pre-punch them for customers . . . with no extra charge for the hole.

[Queenie Bee]

Have you thought about punching your own andy ???


Sent from my iPhone using ProBoards

[amd]

Is it dual coils I need to go on Provari, or will either work as good as each other ?

[Bluefish]

Either will work, tis personel preferance, depends a bit on what volts you going to vape at, i'd get at least 2.5 ohms

[Karma]

pobably cheaper and more convenient to buy a hole punch and punch your own

[amd]

Min 2.5 ohms and a whole punch it is then

Thank You

Andy

[Bluefish]

No problemo

Andy

[amd]

Do the standard boge cartos fit a tank once punched or do you have to get ones with a flanged end ?

[Karma]

apparently they fit this one

www.vapeescape.co.uk/35mm-dc-tank-kit~337

the tank i have will take xxl boges but i'm still using it with the flanged cartos, so I've yet to try it

edited to add.... I am using punched standard boges in a couple of home modded tanks (not modded by me) and they work fine no leaks

[DiscoDes]

May 23, 2012 22:06:03 GMT amd said:

Do the standard boge cartos fit a tank once punched or do you have to get ones with a flanged end ?

Standard Boge's are 35mm I think and will slide down without a flange, no biggie really I have used carto's without flanges in my 3.5ml tank before.

[Bluefish]

May 23, 2012 22:06:03 GMT amd said:

Do the standard boge cartos fit a tank once punched or do you have to get ones with a flanged end ?

If it has a flange, then you can only push the tank on from the top, without flange then you can push it on both ways

[amd]

I want to order 3omn Boge carts so I can use the upper volt settings on my Provari and these seem to be the best carts out at the moment. Are single, dual or bottom coil the best type to go for -?

All a bit baffling still.

Also, what tank would you use on a mini provari ? I am looking for something or similar diameter and fairly short like a lil mama but I am bit concerned about leakage without a flange but also want standard resistance but there is no flanged version

Andy

[Perpetua]

I'd buy a pack of Boges & Kangers ( bottom coil ) and try them both to see what you prefer Andy . . . it's down to personal choice as much as anything, rather than which is best.

They'll both fit a shorty 35mm tank as well. I haven't had any leakage with mine, they're quite a snug fit.

[Gordy]

the only function of the flange is to prevent the tank moving down on the carto but if you are using a device like the provari it hasnt got any where to move to any ways.... the flange wont prevent leaking as thats the job of the O ring seals that keep the juice in. so if they are nice and tight you''ll have no problems.