6 volt vaping

[gaz0012]

Looking at using my ego v6 but everything i try it just kills the flavour tryed diffrent juices but with no luck,what do you use and what mix of pg/vg works best.

[River]

Gaz
Not many people vape at 6v....i personally vape 4.5-4.7v 20mg juice 70/30 pg/vg
although i have the device to go higher as you state it just kills the flavour,most people find anything from 4.2v -5v suits best

[Gordy]

its not anything to do with the mix of the juice ...its to do with the over all power, wattage
juice will taste burnt at say anything over 12 watts (guesstamate)
watts = voltage² / ohms

therefore to vape at 6volts you will need to use a 3ohm atty/carto


................................................................................

if you are using 2.5ohm carto

volts² /ohms = watts
36 / 2.5 = 14.4watts (which will more than likely burn the juice)

[Queenie Bee]

My Lordy rip your throught out or what lol 4.8 max for me and that is with a 2.5 ohm carto I once got brave and went above 5 I shan't be going there again in a hurry :-|

[maccafan]

6 volt should be ok with 2 ohm dual coils if the mod and battery can supply the current..

[hissie]

Crickey..6v is a voltage only for the very daring vaper at lol.

I generally vape 4.7v, maybe 4.8v at times. I find that coupled with a standard boge does the job.

[Perpetua]

6 volt vaping was all the rage when I first started vaping, using stacked batteries on mods that could handle that of course.

High Voltage/Resistance atomisers were required, carto's weren't really about then . . . then Variable Voltage, better Low Resistance stuff came onto the market and 6v vaping became a bit redundant.

As Gordy says, at least 3ohms to avoid a burnt juice or as Macca advises 2ohm DC's . . . they give quite an acceptable vape at 6volts.