sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 22, 2012 19:47:14 GMT
And they are, apparently, talking about releasing bigger (10ml and 15ml) tanks later. But I see they possibly have a few basic things to sort out first.....proving the old adage about never buying version 1 of anything.
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 22, 2012 19:17:30 GMT
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 22, 2012 19:12:02 GMT
Just a quick point. Do remove the inner silicone top and the pip before you dry burn other wise the coils will burn the silicone and it will taste terrible.
Put them back on after you have finished dry burning.
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 17, 2012 6:45:26 GMT
I think its an issue with a poorly fitting silicone seal around the centre connection pin. I agree you may get some condensation down the centre tube, but that would not account for a tank emptying itself.
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 16, 2012 9:27:28 GMT
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 16, 2012 8:59:58 GMT
Any experienced drippers care to comment on the reports that dripping atties tend to leak/seep into the battery connection and the use of a DCA or dripshield to stop this?
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 15, 2012 15:52:10 GMT
I use a prepaid credit card for internet purchases that need card. Something like www.mycashplus.co.uk/You can only spend what you load onto the card in the first place and if it is ever compromised for any reason you only lose, at worst, the funds that are on the card at that time. I load the card from my bank account using the on-line banking. |
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 15, 2012 15:31:06 GMT
Does your new address have any past bad credit history associated with it?
It may be your new address that is being blocked.
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 15, 2012 15:25:51 GMT
There's a more compact version by the way: Power = (Voltage x Voltage) / Resistance From the chart, it seems you should normally aim between 4 and 8 watts. Agreed. A combination of research, empirical evidence and experimentation shows that (generally) less than 3.5W will produce inferior vapour and over 8W may just be too hot or burn things out. That's not to say you cannot necessarily go outside these limits by a small margin. That's up to you. It is just a guide...it's not definitive. And I had to write "V squared" as I could not figure out how to get a superscript 2. >  |
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 15, 2012 12:35:14 GMT
I have posted this on other forums, so some of you may have seen it before. A common question often asked about what combination of voltage and resistance work together. This chart shows that in a graphic format. THIS CHART REFERS PRIMARILY TO SINGLE COIL DEVICES.
DUAL COIL DEVICES HAVE THE POWER SHARED ACROSS TWO COILS (HALF EACH) AND WILL OPERATE WITHIN THE UPPER MARGINS TO GET NEARER 4W IN EACH COIL. |
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 14, 2012 12:20:26 GMT
UKVapers.com has closed for good.
UKVapers.org is now up and running.
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 13, 2012 11:04:40 GMT
Gald they've got the PG back in. It's been unavailable for ages. Bought some straight away now. |
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 12, 2012 16:58:30 GMT
Hello from the rest of us UKV folk.
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 12, 2012 16:56:46 GMT
Hello here too. #grouphug#
|
|
sej016
Mod Maker
Mainly E-Pipe Mods.
Joined:June 2012
Posts: 489
Location:
Likes: 703
Recent Posts
Last Online May 20, 2018 19:19:42 GMT
|
Post by sej016 on Jul 12, 2012 15:44:05 GMT
It's probably OK Pharma grade Glycerine....difficult to say without seeing all the writing on the bottle.
Odd about Boots, since their supplier is one of their own Companies and also based in Nottingham.
|
|
