Recent Posts

Well I'm assuming it's a clone as it's only £16 :

greyhaze.co.uk/products/iatty-genesis-style-rba


I realise the RSST would be easier to work with due to the insulated wick hole & poly tank, but I've got on ok with the Aga-S so far.

Well, apart from the drilling failure 


Plus I've spent a bit in the past week with a Vamo v2, a cheap K-100 from FT - which I still need to buy a kick / protected batteries for, and having to also change juices to a 50/50 mix due to potential side effects.

So, the £8'ish saved over the RSST would be nice

This is what I get for not doing my maths beforehand

I'll fill the current one & re-drill a new one at 1.2mm this time. Think that should be big enough.

If I botch it I'm not too worried as the Aga-S was really just to see if I would get along with RBA's in the first place.

And I do! Well apart from the drilling bit...

I knew it wouldn't take long to descend into the depths on here

And here I was trying to be nice n polite keeping my original thread 'clean'

Hey all,

Got my SS Vamo V2 yesterday, so I finally got to try out the AGA-S I bought 2nd hand earlier in the week.

Wicked & coiled with the bits johnners supplied to me.

1.5ohms. No hotspots. Good to go.

Lined the airhole up with the wick, set the Vamo to 9.5 watts and pressed fire!


Great flavour, not quite the throat hit I was expecting ( my 1.8ohm cartos hit harder with the same juice ) and plenty of vapour.


So I decided to drill it out to 1.5mm...


This produced more vapour, a bit more throat hit but less flavour. It tasted like I was vaping an Evod or T3s again.

I'm quite surprised that 0.5mm made the difference it did to be honest. Didn't think it would be that noticeable.

At least I now know that 1mm is too tight for me & I find 1.5mm a bit to airy.

Now to fill the hole in and drill a new 1.2mm hole instead.


And I'm now done for as I finally bit the bullet & opened a Fasttech account to order a blue K100.

Sadly I noticed that CharliesVapeShop is selling them on their own for not much more cash the following day, or I'd have it by now also.

Quickest way I've found to fill a carto is to fill the tank up to around 80%, push the carto up fully, stick on the drip tip and then, with your finger over the 510 connector, suck on it repeatedly to draw the juice through the holes into the carto filler material.

Remember to take your finger off the 510 connector between draws to allow air in.

You should see air bubbles coming from the holes in the carto, going up inside your tank. Takes around 5 minutes to do :



You can tell when you're almost done as the draw will become ever so slightly gurgly instead of just airy.

Just be sure to check take the drip tip off & check the filler material to make sure it's moist / has changed colour before using.

Some cartos, like the DCT ones LTeCigs sell only take 1min to do. You can actually see the liquid level drop in the tank while sucking due to the large slots in the carto.

Johnners came to the rescue in my search for an AGA-S.

He also included some spare mesh & wire as well, along with the spare o-rings.

Kept in touch via pm's & it arrived within 48hrs of my Paypal payment.

Thanks again j.