|
|
Post by chrisvaper on May 22, 2014 14:24:29 GMT
Thanks, can really recommend this.
After charging my battery I went to unscrew it and the bit (that you screw into) inside the charger broke away from the PCB, in fustration I pulled on the charger and it ripped off the top of the battery.
Both charger and battery now knackered.
I'm not normally one for screwing overlay tight, but lesson learnt.
Chris
|
|
|
|
Post by chrisvaper on May 16, 2014 8:51:39 GMT
Hi there, still new to vaping (2 weeks off cigs now) started out with a socialites kit CE4 clearomiser on ego battery, then bought an Aspire Nautilus with 1.8 ohm BDC which I am loving.
I wasn't sure if I was getting best performance of the Nautilus on an old ego battery a friend gave me (volt meter reading of 3.8V) so I purchased a SS Vision Spinner 1300mAh 3.3 to 4.8V so I could try various voltages. However on first use straight away I got that burnt taste but with huge amount of vapour, I couldn't seem to get it to perfom at any voltage.
I checked the voltages with a meter and straight away something seemed off at the lowest setting of 3.3v the meter showed 4.15v and this difference seemed fairly constant as you dialled up, at 4.8v I was getting 5.7v.
Does not seem right to me, maybe I am doing something wrong here, can I use my Aspire on this battery?
Thanks
Chris
|
|
