Is it ok to Vape a clearomiser dry?

[MarkS]

I know I have to continuously top up Cartomisers, but does the same count for Clearomisers?

Can I Vape on a Clearo until no more liquid is present before refilling?

[Karma]

The wicks need to be kept wet to avoid dry hits

[Sandra (aka Chillax)]

To dry and it will burn

[MarkS]

Thank you Karma & Sandra, so best not let it get to low then I guess.

Whilst you are here, could you recommend a decent Atomiser for my Riva so I can drip test flavours?

Not a rebuild one though.

[Karma]

Most people recommend a 306 for testing juices

www.safercigs.co.uk/19ohm_Bauway__306__Atomizer_19ohms/p705283_8294594.aspx

with

www.safercigs.co.uk/306_Drip_Tips/cat705284_871233.aspx

[Sandra (aka Chillax)]

I would go for the 306 as well, fantastic atty

[Ewol]

Feb 20, 2013 16:01:26 GMT Karma said:

Most people recommend a 306 for testing juices

www.safercigs.co.uk/19ohm_Bauway__306__Atomizer_19ohms/p705283_8294594.aspx

with

www.safercigs.co.uk/306_Drip_Tips/cat705284_871233.aspx

Speaking of which. I had a 306 drip tip and I lost the bloody thing. I've looked under my bed and everything, it's nowhere to be found! :-S

I'm a messy bugger.

[MarkS]

Thank you both.

I'm on it.

[Ewol]

Mark, just a little advice. If you're planning to try a lot of juice on it, skip the Menthol and Coffee flavors. It will more or less ruin an atty and you won't be able to try out other flavours. Menthol and Coffee are just too strong.

[MarkS]

Thanks Ewol. I think I'll use an individual Carto for each of those flavours then.

[Banky]

Best way to test flavours

[MarkS]

Can I also ask does rinsing out Clearos with warm water shorten their lifespan at all?

[Roscopecotrain]

No it should be all good mark, give it a quick dry burn every couple of days at least to get the crap off the coil or give the clearo a soak in vodka over night.

[MarkS]

Thank you Roscopecotrain.

I'll have to grab a bottle of voddy tomorrow.
Would isopropyl alcohol also work or does it leave a nasty taste?

[kibbster]

I can't say about a 306 atty for dripping because I've never used one.
An ordinary 510 atty works very well for dripping and should be cheaper than a 306