Kayfun Lite 510 screw

[smarties]

Vaping quite happily on my super expensive (£8.60) Kayfun Lite from slowttech, the only thing that bugs me is the 510 screw is short so it will not fire on some mods, in fact the only one it will fire on is my Nemmy clone and then it's screwed up so much there is only about 2mm of throw in the switch.
tried removing the kick ring but then the throw is way too long, is there any way of extending the screw or is that a stupid question, can't find anything on the magical Google so a bit stumped really.

Any suggestions?  

[Grandad]

I just recieved mine in the 510 connecter is there a slot can you not unscrew it half a turn to make a connection. This is all new to me but looked at mine and i can unscrew the screw and it comes down 1mm or so maybe enough to connect.

[smarties]

I'll give that a try Grandad though I thought if I did that it would loosen the coil base on the atty deck risking a short, worth a look when having a refill, thanks.

[marlbororman]

strange, both mine fit all 6 of my mods and batteries :s

[johnners]

I broke the 510 pin on my Fasttech KFL as soon as it arrived :/
I took it apart to clean and when I put it back together the pin just snapped. They are very weak it seems, so becareful if you're adjusting it
It should unscrew a little though, but check that it doesn't leave the block on top of the deck too loose as this might cause a short.

[Greg]

smarties you can buy a longer upper contact for the nemesis

There you go myfree-cig.com/Longer-upper-contact-pour-Nemesis/en

postage not bad either 

[enjay]

That screw holds the positive post of the atty, you can't really loosen it off but you could maybe remove it and fit a small washer in behind it?

[smarties]

Thanks Greg and enjay it might be a case of trying both