Rose v2 clone help

[Deleted]

Jan 23, 2015 20:08:22 GMT fartvaper said:

 without the o ring, not much of a gap though

Thats more like it

[colli]

Hi just to say you managed to screw it on so it must unscrew as well

I also have a clone and had a similar issue I found after filling, screw the tank on a turn or two (enough to seal it) and then quickly push up the chimney, turn it upright and tighten a couple of turns then screw the tank right down and adjust the juice control down then try and open up as you require, mine is almost completely open with no leaks/gurgles

[fartvaper]

This is the maximum it will open with the tank on.
I'll give it a go over the weekend. 
After the day i have had at work, I'm not in the right frame of mind 

[arron]

fartvaper I have pretty much all the spare parts required for the Rose inc bottom section, chimney etc etc...if you don't get any luck sorting it then post it to me and I will sort it out, chuck a build on for you and post it back

[igual]

Stick a straight edge up against chimney. Just in case it is bent.
Lube up the oring on the driptip with juice ( Durex play or ky) your choice
Could it be possible that he has a stumpy kit but full sized chimny. Haven't got the stumpy kit but thought I'd throw idea out there.

[fartvaper]

Jan 23, 2015 23:56:46 GMT arron said:

fartvaper I have pretty much all the spare parts required for the Rose inc bottom section, chimney etc etc...if you don't get any luck sorting it then post it to me and I will sort it out, chuck a build on for you and post it back

Thanks very much arron, if I don't get any luck i'll take you up on that.
got to make a video & put on a 3rd party site, what a ball ache

[robby]

Try the tank with the o ring removed from the top of the chimney, obviously do it with an empty tank. Mine was a pain to use until I found an old worn o ring out of something else. Worth a try even if you haven`t got a spare

[fartvaper]

Thanks for the idea@robby. It's no different, I can feel it hitting the stepped part of the juice control

[igual]

Sounds like the stepped lip is to high.
I'd guess a machining error maybe.
Unfortunately mine is full of juice atmo so can't measure it.

[fartvaper]

That's what I thought igual

[robby]

Bent chimney maybe?

[robby]

If you have the chimney and the atty top separate (off the mod) can you get the chimney through to where it should be

[fartvaper]

It's straight. I think it's a machining error. I don't own a lathe, so I can't turn it down a little. It will probably work without that o ring, I'm more gutted that it didn't come with the clear tank or any spares

[fartvaper]

Jan 24, 2015 10:43:54 GMT robby said:

If you have the chimney and the atty top separate (off the mod) can you get the chimney through to where it should be

Yes. and it slides through easy

[robby]

Must be bent?